The Trusted Source

®

4-Way Trailer Tow Harnessfor Jeep Wrangler 2007-2013 (JK)

Installation and Instruction Manual#92015.8001

REQUIRED TOOLS:PHILLIPS HEAD SCREW DRIVER (P8)10mm WRENCH (TO DISCONNECT BATTERY)

PARTS LIST:WIRING HARNESS (1)

VEHICLE BATTERY MUST BE DISCONNECTED DURINGWIRING HARNESS INSTALLATION.

FAILURE TO DISCONNECT BATTERY COULD RESULT INELECTRICAL SHOCK TO THE PERSON PERFORMINGINSTALLATION.

FAILURE TO DISCONNECT BATTERY COULD RESULT INDAMAGE TO VEHICLE ELECTRICAL SYSTEM.

READ ALL SAFETY MESSAGES AND UNDERSTAND ALL INSTRUCTIONS AND PROCEDURE NOTICES BEFORE ATTEMPTING TO INSTALL OR USE THIS PRODUCT.

4-WayHarness Plug

Female TowHarness Plug

Male TowHarness Plug

JK_HARNESS_92015_8001_A4_A4 5/24/13 12:11 PM Page 1

05242013121452

The Trusted Source

®

2

Step One:Make sure that your vehicle is in gear or park and emergency brake is set.Disconnect the negative battery terminal using a 10mm wrench.

Step Two:Remove the driver side tail lamp by removing the two fasteners pointed out using thePhillips head screwdriver.

Step Three:Carefully disconnect the taillamp plug to the car harnessby depressing the locking tabon the female plug end torelease the plug connection.

Depress lockingtab to disconnecttail lamp plug

JK_HARNESS_92015_8001_A4_A4 5/24/13 12:11 PM Page 2

05242013121452

The Trusted Source

®

3

Step Four:Connect the male car harness plug end into the female tow harness plug end. Be surethat the plug is fully engaged with the locking tab. Insert the plug clips on the towharness to the tail lamp clip dock.

Step Five:Connect the male tow harness plug end to the vehicle’s female tail lamp plug.Be sure that plug is fully engaged with the locking tab.

Male Car Harness Plug

Female Tow Harness Plug

Insert Tow Harness clip into tail lamp dock

Electrical connections complete

JK_HARNESS_92015_8001_A4_A4 5/24/13 12:11 PM Page 3

05242013121452

The Trusted Source

®

4

Step Six:Take the 4-way tow harness plug end and feed it through the tail light opening anddown inside the car body to the notched corner of the foam panel located at the backof the wheel well. Continue to pull the tow harness cord through the notch until thefourth fastening clip passes through. Feed the harness over the top of the vehicle frameand towards the receiver hitch. Push the last clip (the one closest to the tail lamp) intothe existing hole on the body at the location shown.

Foam panel

Fastening clip #4

Tow Harness

Close-up of HarnessFastening Clip

JK_HARNESS_92015_8001_A4_A4 5/24/13 12:11 PM Page 4

05242013121452

The Trusted Source

®

5

Step Seven:Press the 3 remaining tow harness clips into the “existing” factory holes on the insideframe rail and rear cross member as illustrated. Make sure that the tow harness is atleast several inches away from any exhaust components.

Step Eight:Press the 4-way harness plug up and into the plug clip located on theleft side of the receiver hitch (if applicable).

Hitch

Fastening Clips 4, 3 & 2

4-Way TowHarness Plug

4-Way Tow Harness Plug

JK_HARNESS_92015_8001_A4_A4 5/24/13 12:11 PM Page 5

05242013121453

The Trusted Source

®

6

Step Nine (Final):Reinstall the two tail lamp fasteners that were removed earlier and reconnect thenegative battery terminal.

Immediately check vehicle tail lamps and trailer lamps to ensure that both turn sig-nals, brake, flasher, driving and backup lamps are all functioning properly. If not,double check your work or seek a professional automotive technician since a problemmay exist within the “trailer” wiring.

If you have a question specific to your purchase, our customer service staff is standingby. Call toll free: (800) 745-6037 or visit our #1 rated website at www.quadratec.com

JK_HARNESS_92015_8001_A4_A4 5/24/13 12:11 PM Page 6

05242013121453

The Trusted Source

®

7

NEW! Q-SeriesSelf Recovery Winches The first winches designed and engi-neered specifically for your Jeep®.The Q9000 provides all of the capa-bility that most enthusiasts will everneed. The Q11000 provides evenmore capability for heavier Jeeps likethe 4 door Wrangler Unlimited. Nowyou get the lowest price of anywinch in this class. Our engineerswork directly with the factory to pro-vide features specifically tailored toyour Jeep. Our powerful 4.8 HP series wound motorand class leading low gear ratios give fast linespeeds with a Battery Friendly low current draw.You’ll get the most winching time from your avail-able battery charge. Our Winches include two setsof solenoid brackets for side mounting or top mount-ing. Enjoy an industry best Limited Lifetime War-ranty on mechanical parts and a 1 year Warrantyon all electrical components. Detailed installationinstructions and a handy glove compartment sizedOwners Manual with Winching Guide are included.

Q9000 Self Recovery Winch Grey #92122.2000

Q9000 Self Recovery Winch Black #92122.2010

Q110 00 Self Recovery Winch Grey #92122.2001

Q110 00 Self Recovery Winch Black #92122.2011

Winch Mount Plate for ’07-’13 Wrangler #12065.1010

2 Solenoid Positions!

Q Series

Q9000 Shownwith Solenoidin Top mount

position.

Q11000 Shown inBLACK Finish with Solenoid in the side mount position.

All versions come witha Hi-Viz RubberizedRemote with 12’ Cord

Forged Steel Clevis Hook andCustom “Quadratec Green”Nylon Safety Strap

StartING At $294.99!

Go online or call for latest price...

JK_HARNESS_92015_8001_A4_A4 5/24/13 1:51 PM Page 7

05242013135239

The Trusted Source

®

8

Quadratec® ExclusiveThree Year Limited Warranty

Your Quadratec® branded accessories arecovered by the following Limited Warrantyprovided exclusively by Quadratec, Inc., 1028Saunders Lane, West Chester PA 19380.

This Limited Warranty is the only warrantymade in connection with your purchase.Quadratec neither assumes nor authorizes anyvendor, retailer or other person or entity to as-sume for it any other obligation or liability inconnection with this product or Limited War-ranty. This Limited Warranty does not applyand is not cumulative to any accessory or partdistributed by Quadratec for which the Manu-facturer provides a separate written warranty.

What is Covered: Subject to the terms, exclu-sions and limitations herein and with respectonly to Quadratec branded accessories first soldin the United States, Quadratec warrants to theinitial retail purchaser only that yourQuadratec accessory shall be free of defects inmaterial and workmanship: for a period ofthree (3) years from date of retail purchase.

This Limited Warranty is not assignable andshall terminate upon sale of the vehicle uponwhich the Quadratec accessory is installed orother transfer third persons.

All other warranties are hereby disclaimed, ex-cept to the extent prohibited by applicable lawin which case any implied warranty of mer-chantability or fitness for a particular purposeon this product is limited to 3 year from date ofinitial retail sale. Quadratec reserves the rightsto: (a.) require invoice or other proof your ac-cessory is within the terms of this LimitedWarranty as a condition of warranty serviceand, (b.) make future revisions to this productand Limited Warranty without prior notice orobligation to upgrade your product.

What is Not Covered:Your Quadratec Limited Warranty does notcover products or parts Quadratec determinesto have been damaged by or subjected to:

(a.) installation damage, alteration, modifica-tion, combination with other parts, failure tomaintain or improper repair or service, (b.) nor-mal wear & tear, cosmetic damage or damagefrom moisture or water immersion, (c.) Acts ofGod, accidents, misuse, negligence, inadequatemounting or impact with vehicle(s), obstaclesor other aspects of the environment, (d.) theft,vandalism or other intentional damage.

Remedy Limited to Repair/Replacement:The exclusive remedy provided hereunder shall,upon Quadratec inspection and at Quadratec’soption, be either repair or replacement of prod-uct or parts (new or refurbished) covered underthis Limited Warranty. Customers requestingwarranty consideration should first contactQuadratec to obtain a RGA number(610-701-3336). All labor, removal, shippingand installation costs are customer’s responsibility.

Other Limitations - Exclusion of Damages -Your Rights Under State Law:In consideration of the purchase price paid, nei-ther Quadratec nor any independent Quadratec distributor/licensee are responsible for any timeloss, rental costs, or for any incidental, conse-quential, punitive or other damages you mayhave or incur in connection with any part orproduct purchased. Your exclusive remedyhereunder for covered parts is repair/replace-ment as described above.

This Limited Warranty gives you specific rights.You may also have other rights that vary fromstate to state. For example, some states do notallow limitations of how long an implied war-ranty lasts and /or do not allow the exclusionor limitation of incidental or consequentialdamages, so the limitations and exclusionsherein may not apply to you.

©Quadratec, Inc. 2013. All Rights Reserved.Version 5.23.13

Part #12999.3006

JK_HARNESS_92015_8001_A4_A4 5/24/13 1:51 PM Page 8

05242013135239