Apple MacBook Pro RAM Installation 13” Models released Mid 2009, Mid 2010

15” Models released Mid 2009, Mid 2010, Early/Late 2011, Mid 2012

What do I need? Clear Workspace

New RAM Module(s) Screwdriver

To prevent potential damage from anti-static electricity, you should discharge yourself first.

This can be done by simply touching a grounded metal

object, such as a radiator.

Installation Process 1 – Make sure the MacBook is

completely shut down and

switched off. Disconnect any

cables.

2 – Turn your MacBook over and

remove the 10 screws that are

securing the bottom case.

Remember where each screw came

from.

3 – Pry the back of the case away

from the MacBook.

7 x 3mm

3 x 13.5mm

4 – To remove any existing RAM,

push the levers on the sides of the

module away from the module. The

module will pop out as an angle.

5 – To install the new module, align

the notch on the gold part of the

module with the notch in the slot.

Tilt the card and push the memory

firmly and evenly into the slot.

There will be an audible click when

the memory is seated correctly.

Do not worry which way the stickers

face, as this will differ.

To reassemble the MacBook,

reattach the back panel and replace

the 10 screws into their locations.

Turn the Mac back on. Everything

should be running smoothly and

quicker than before.

Email – support@mrmemory.co.uk

Tel – 01903 692 214