Document Camera - Connecting to a Laptop(Lumens DC162 Digital Visualizer)

1. Place document camera on a hard surface fairly close to your computer. The connecting cable is approximately five feet long. Do not block ventilation openings on the base of the document camera.

2. Make sure the package comes with the following items when you unpack. You are responsible for returning these items.

1. DC1602. Remote3. User’s Manual4. Power cable5. VGA Cable6. DVI Adapter 7. USB Cable

3. Connection –Each time you hookup the document camera, connect the document camera in the

following manner.

1. [Use the DVI connector]a) Put the DVI connector in the (DVI Out) port on the document camera base.

2. [Document Camera VGA cable]b) Plug one end of the document camera VGA cable into the VGA plug in the laptop

computer.

c) Plug the other end of the document camera VGA cable into the DVI adapter which is plugged into the document camera base.

3. [Projector VGA cable]a) Plug one end of the Projector VGA cable into the “VGA OUT” port in the back of the document camera base.

b) Plug the other end of the Projector VGA cable in the “COMPUTER 1 IN” port on the projector

This picture shows the cable plugged in correctly.

5. [Power cord]a) Plug the Power cord into the “AC IN” port in the document camera base and into the wall socket.

Projector cable from document camera base.

6. [USB cable]

USE THE USB WHEN YOU ARE CONNECTING TO AN INTERACTIVE WHITEBOARD.

a) Plug the square end of the USB cable into the “USB” port in the document camera base.

b) Plug the flat end of the USB cable into a USB port on the laptop.

TAKE NOTE OF THE USB PORT YOU USE!

Note: Take note of the USB port you use, because you must use the same port each time for the USB cable! Otherwise, your document camera will not function properly; you will be required to reinstall the software for each port.

The document camera base will look like this when all plugs are in.

Document Camera Base

TAKE NOTE OF THE USB PORT YOU USE TO CONNECT TO THE COMPUTER!

IF THIS IS THE OPTION YOU PREFER, YOU MUST CONTACT THE HELP DESK AND ASK A TECHNICIAN TO INSTALL THE SOFTWARE ON YOUR DESKTOP OR LAPTOP.

After installation, you should see this icon on your desktop.

Power cord

Projector VGA cable connects to “COMPUTER 1 IN” port in back of projector

VGA cable from computer

DVI Adapter

USB cable connects to computer -square end here

To connect to your computer to interact with the document, the following software must be installed.