Upload
ajhillgolf
View
372
Download
0
Embed Size (px)
DESCRIPTION
Dodge Ram Radio wiring harness diagram
Citation preview
In no event shall Scosche be responsible forclaims beyond the replacement value of thedefective product, or in any way liable or re-sponsible for consequential or incidentaldamages.
FACTORY STEREOCONNECTOR
Using the appropriate Scosche "Car StereoConnector" to adapt to your vehicle'sFactory Wiring Harness Connector inconjunction with the "Factory StereoConnector" will eliminate the need to cutany of your factory wires.
©1998 SCOSCHE INDUSTRIES, INC. 9/98
If you have any questions, you may call our tollfree technical help line at: 1-800-621-3695, x3
Helpful Hints:� The wiring colors of the Factory Stereo Connector
may be different from the wiring colors found on yourstereo.
� Refer to the section entitled "Wire Color Codes"found in this instruction to verify all the wirefunctions. Always use a test light and/or voltagemeter to test wire functions first.
WIRING INSTRUCTIONS:1. Using a test light or voltage meter, determine wire
functions for each of the factory stereo wires foundin your vehicle's dash. i.e. Determine which wire is12 volt constant, 12 volt switched, ground, dimmer,etc.
2. Determine which wires are positive and negative foreach speaker in the vehicle.
3. Disconnect the negative battery cable from thebattery to avoid any short circuits.
4. Match and connect the appropriate wires from theFactory Stereo Connector to the appropriate wiresin the dash previously determined in steps one andtwo.
5. Verify that all wires of the Factorty StereoConnector are connected to the proper wires inyour vehicles dash, and that all connections aresecure.
6. Tape all unused wires to prevent short circuiting.7. Reconnect the negative battery cable to the battery.8. Insert the Stereo Connector into the stereo.9. Check all functions including the fader and balance.
Refer to your stereo owners manual if necessary.
FACTORY HARNESS
WIRE COLOR CODES:The Factory Color Codes Are Not Available At ThisTime. Please Refer to The PIN Location Below.
7 WIRE PLUG (BLACK)
PIN #
1. = Power Antenna
2. = Left Rear Positive (LR+).
3. = Right Rear Positive (RR+).
4. = Left Front Positive (LF+).
5. = Right Front Positive (RF+).
6. = Left Rear Negative (LR-).
7. = Right Rear Negative (RR-).
7 WIRE PLUG (GRAY)
PIN #
8. = Not Used.
9. = Left Front Negative (LF-).
10. = Right Front Negative (RF-).
11. = Not Used.
12. = Illumination/Dimmer.
13. = 12 Volt Ignition/Switched (12V+).
14. = 12 Volt Battery/Constant (12V+).
CHRYSLER
1995-UPCIRRUS
1993-UPCONCORDE
1983-84 E CLASS
1979-UPFIFTH AVENUE
1981-UPIMPERIAL
1994-UPLHS SEDAN
1984-86 LASER
1984-UPLE BARON
1995 NEON
1979-UPNEW YORKER
1995-UPSEBRING
DODGE
1983-88 600 ES
1985-89 ARIES
1995-UPAVENGER
1984-UPCARAVAN
1983-87 CHARGER
1987-UPDAKOTA
1984-UPDAYTONA
1977-89 DIPLOMAT
1988-UPDYNASTY
1993-UPINTREPID
1985-89 LANCER ES
1978-90 OMNI
1981-UPPICKUP,
FULL SIZE
7 WIRE PLUG (GRAY)
7 WIRE PLUG (BLACK)
1
2
3
4
5
6
7
8
9
14
13
12
11
10
DODGE (cont.)
1994-UPRAM TRUCK
1981-89 RAMCHARGER
1987-UPSHADOW
1989-UPSPIRIT
1995-UPSTRATUS
1984-UPVAN
EAGLE
1993-UPVISION
JEEP
1993-UPGRAND
CHEROKEE
WAGONEER
PLYMOUTH
1989-UPACCLAIM
1985-88 CARAVELLE SE
1980-89 GRAN FURY
1978-90 HORIZON
1995 NEON
1985-89 RELIANT
1987-UPSUNDANCE
1983-87 TURISMO
1984-UPVOYAGER
Scosche CR01 Wire ConnectorRecommended
Scosche CR01 Wire ConnectorRecommended