Upload
hoangcong
View
237
Download
5
Embed Size (px)
Citation preview
FOR-450
Dimensions on displacement positionLength: 2,470 mm (8.10 ft)Width: 1,200 mm (3.94 ft)Height: 1,720 mm (5.64 ft)
Dimensions on working positionLength: 2,470 mm (8.10 ft)Width: 1,200 mm (3.94 ft)Height: 2,090 mm (6.85 ft)
• Remote controlled, self-propelled rubber track with 1,200 mm width
• Rotation head equipped with 2 Danfoss hydraulic motors
• Fully automatic with injection swivel, single or double rod clamp and manipulation winch
• CE certified
The For-450 is a compact, economic and versatile drilling rig designed for geotechnical investigation as well as environmental drilling.
Equipped with a 45 HP DEUTZ diesel engine, small size and a wide range of accessories and options, the FOR-450 is the perfect choice for site investigation in areas with difficult access.
The rotary percussion head comes with two hydraulic motors and a hydraulic hammer, allowing you to use all drilling techniques and a wide range of torques and rotation speeds. The lower water swivel is left and right threaded.
The FOR-450 from Fordia can become fully automatic by adding several options such as: rod clamp, injection pump, manipulation winch, hydraulic sliding of the rotation skid, as well as a hydraulic capstan for SPT testing.
WEIGHT
METRIC IMPERIAL
TOTAL (DEPENDING ON OPTIONS)
1,800 to 2,400 kg
3,968 to5,291 lb
POWER PACK
DESCRIPTION
DEUTZ SOUNDPROOF ENGINE 45 HP
FUEL TANK 35 L
OIL TANK 90 L
PUMP Triple - Fixed capacity
DISTRIBUTORS Danfoss PVG 32
TRACK
DESCRIPTION
TRACK Remote controlled - Fixed width
WIDTH 1,200 mm
OPTIONS
DESCRIPTION
WATER INJECTION PUMP 80 L/min - 40 bars
MANIPULATION WINCH 500 kg
ROTATION HEAD Hydraulic sliding160 daNm and 400 rpm
CHASSIS
DESCRIPTION
Mechanically welded steel skid
4 hydraulic stabilization jacks
MAST
DESCRIPTION
LENGTHS 2,100 - 2,500 - 3,500 mm
FEED Gear motor and chain
PULL-BACK CAPACITY 2,500 kg (5,512 lb)
PUSH-DOWN THRUST 1,500 kg (3,307 lb)
DRILLING DIAMETER 200 mm max.
ROD CLAMP Simple - 170 mm
ROTATION HEAD
DESCRIPTION
HYDRAULIC MOTORS Danfoss (2x)
MAX. TORQUE 0 to 190 daNm
MAX. SPEED 0 to 260 rpm
PERCUSSION FORCE 220 joules/blow
PERCUSSION FREQUENCY 1,200 bpm
INJECTION SWIVEL Air/water
THREADS Male 2”3/8 IF and Female R38
A user-friendly general control panel holds the control levers and gauges.
Mounted on a self-propelled rubber track that is 1,200 mm wide, the FOR-450 has four hydraulic stabilization feet and a mast that can be raised by hydraulic jack, allowing an easy and quick set-up for drilling operations.
This product is CE certified and is equipped with all the necessary emergency stops and safeties to protect operators.
T 514 336-9211 TF 1 800 768-7274 [email protected]/GEOTECHNICAL
© 2014 Fordia. All rights reserved. H-14 14-03-371