INSTALLATIONINSTRUCTIONS

FRAMELESS SLIDING DOOR FOR TUB OR SHOWER

QCI5019 Rev 0 Page 1 Certified 06/21/2016

Lysol

Although safety tempered glass is very resistant to breakage, theglass can still break if unequal pressure is placed on it duringinstallation. Use caution. In addition, the sharp corners of thepanels can damage tile and floor surfaces, so it is best to handlethe glass panels carefully and protect the edges.

Two primary materials are used to manufacture your new enclosure: tempered glass and anodized aluminum. To assure a long lasting finish on the enclosure, wipe it down with a towel after each use.Never use a scouring agent to clean the aluminum.

To install your bath enclosure, you will need the following:

QCI5019 Rev 0 Page 2 Certified 06/21/2016

**If installing on a fiberglass unit you may need to snip outside corner to match corners on wall jambs and tub tracks to match radius on fiberglass unit**

J. 2 Towel Bar Trim Rings

S. 1 Nylon Bottom GuideT. 2 #6 x 3/8” Pan Head ScrewsU. 4 Stainless Steel Bumper Inserts

v

U

QCI5019 Rev 0 Page 3 Certified 06/21/2016

Certified 12/13/06

)

3/16”

3/16”

QCI5019 Rev 0 Page 4 Certified 06/21/2016

QCI5019 Rev 0 Page 5 Certified 06/21/2016

QCI5019 Rev 0 Page 6 Certified 06/21/2016

QCI5019 Rev 0 Page 7 Certified 06/21/2016

QCI5019 Rev 0 Page 8 Certified 06/21/2016