User

Callout

FRP grating needed here for this void. 82" x 14-3/4"

User

Callout

We need (6) total connector pieces for both pump stations.

User

Text Box

See next page...

User

Callout

24" wide x 81" long, "flat smooth stock", approx 1/4" thick... Essentially it is a "trough" for the wires to lay on. AKA cable tray. It will just bolt to the bottom of the beams in the picture.

User

Text Box

See previous page...

User

Callout

How is this supposed to fasten to the edge of the concrete? These little "A1" brackets were found, but is this the correct way to install? This is PS #3 valve vault.

User

Callout

How is this supposed to fasten to the edge of the concrete? These little "A1" brackets were found, but is this the correct way to install? This is PS #3 wet well.

User

Callout

Misaligned railing holes vs. predrilled.

User

Callout

Misaligned railing holes vs. predrilled.

User

Callout

Need 13-3/4" x 30" piece of grating to fill this void.

User

Callout

Need 14" x 21" piece of grating to fill this void.

User

Callout

How do we attach this piece to the wet well? the slab is approximately 12" thick, so if a "L" bracket of some sort like an "A1" could be built that pokes down at least 16", that should work.

User

Callout

Current measurement from edge of valve vault to center of railing shown above is approximately 6'-8", it should be at 7'-3" to be able to attach to the beam. As shown above it is unable to attach. This is PS #3.

User

Callout

Another misaligned railing holes vs. predrilled.