24
PAPER HOUSES Create a 3D House or Cabin

PAPER HOUSES Create a 3D House or Cabin

Embed Size (px)

Citation preview

Page 1: PAPER HOUSES Create a 3D House or Cabin

PAPER HOUSESCreate a 3D House or Cabin

Page 2: PAPER HOUSES Create a 3D House or Cabin

COOL EXAMPLES!

Page 3: PAPER HOUSES Create a 3D House or Cabin
Page 4: PAPER HOUSES Create a 3D House or Cabin
Page 5: PAPER HOUSES Create a 3D House or Cabin
Page 6: PAPER HOUSES Create a 3D House or Cabin
Page 7: PAPER HOUSES Create a 3D House or Cabin
Page 8: PAPER HOUSES Create a 3D House or Cabin
Page 9: PAPER HOUSES Create a 3D House or Cabin
Page 10: PAPER HOUSES Create a 3D House or Cabin
Page 11: PAPER HOUSES Create a 3D House or Cabin

What ours will possibly look like…

Page 12: PAPER HOUSES Create a 3D House or Cabin
Page 13: PAPER HOUSES Create a 3D House or Cabin

STEP 1: Sketch a Floorplan

Page 14: PAPER HOUSES Create a 3D House or Cabin

Requirements:

• Kitchen• Bathroom• Bedroom 1• Bedroom 2• Living Room• Laundry Room• Dining Room

Page 15: PAPER HOUSES Create a 3D House or Cabin

Base: 12”x 20”

STEP 2: Get a 12”x20” firm base

Page 16: PAPER HOUSES Create a 3D House or Cabin

STEP 3: Draw Floor Plan on Base

You might want to start with the front doorTIP: Use a pencil and ruler!

Page 17: PAPER HOUSES Create a 3D House or Cabin

Use Architectural Symbols

Page 18: PAPER HOUSES Create a 3D House or Cabin

Scale

• 1/2”=1’ (half an inch = one foot)

Page 19: PAPER HOUSES Create a 3D House or Cabin

STEP 4: NEATLY Label and Measure each Room

If a room is 6” x 8” actual size, put 12’ x 16’ beneath the room name.

Don’t forget hallways! They should be at last 3’ (1-1/2”) wide

Page 20: PAPER HOUSES Create a 3D House or Cabin

STEP 5: Walls & Windows

• Cut 4” strips of additional thick paper.• Cut each wall to the correct length for each

room, hallway, etc.• Carefully cut windows and doors out of each

wall where they need to be. Only cut three sides for each door to create a hinge! Use an Xacto knife and metal ruler. BE CAREFUL!

• Hot glue or tape each wall in place. Glue walls together for stability.

Page 21: PAPER HOUSES Create a 3D House or Cabin

STEP 6: External Walls• Cut two 4” tall walls for the front and back of

the house.• Cut two 8” tall walls for the two shorter walls.– These shorter walls will have “gables” (triangular

shaped peaks).

Page 22: PAPER HOUSES Create a 3D House or Cabin

STEP 7: Add a Roof

• Cut a thick piece of paper about ¼” wider and longer than the house.

• Fold it in half length-wise.• Set it in place.

Page 23: PAPER HOUSES Create a 3D House or Cabin

STEP 8:

• Glue house to a green piece of construction paper that is 2” larger than the house on all sides.

Page 24: PAPER HOUSES Create a 3D House or Cabin

DONE!!!