Upload
anonymous-3bd6azesv
View
216
Download
0
Embed Size (px)
Citation preview
8/20/2019 PuigTec EQP-1A
http://slidepdf.com/reader/full/puigtec-eqp-1a 1/3
8/20/2019 PuigTec EQP-1A
http://slidepdf.com/reader/full/puigtec-eqp-1a 2/3
The Original Pultec is built by hand and
is a favorite of many recording and mas-
tering engineers, and came to us in 1951.
The early models had a loss of gain is the-
refore modified and a step of gain added
to the device.
The most important is an analog device
that generates the harmonic distortion,
this is that harmonic to the signal agrea-
ga in multiples and submultiples of the
main frequencies changing its color tone
does not increase or decrease more than0.3 db.
Upon instantiation of the PuigTec EQP-
1A, you may hear a small change in fre-
quency balance, which sounds like top
end boost, introducing about 1dB of
gain. This replicates the actual behavior
of the modeled hardware, and will vary
as you change the low cutoff frequency.This is also an attribute of the original
hardware, caused by the interaction of
its filters.
1
INTRODUCTION
Hello my name is Jose Luis, I'm from mexico and I will write a
little about PuigTec Equalizer EQP-1A and it works.
8/20/2019 PuigTec EQP-1A
http://slidepdf.com/reader/full/puigtec-eqp-1a 3/3
2
Parameters
• The Low Frequency band offers a low shelf for Boost and/or Attenuation at four cutoff points. While
Boost and Attenuation work on the same cutoff frequency, they do not cancel one another out when applied si-
multaneously; rather, they create a resonant shelf.
• Hi Band Boost offers a high bell boost with 7 cutoff points and adjustable Q (bandwidth control).
• Hi Band Attenuation offers high shelf attenuation at 3 cutoff points.
• Gain controls level trimming.
• The Output meter displays peak output level.
Meter displays output level in dBFS. The LED located in the upper right corner lights up when output signal is
clipping.
I hope that the information is very helpful and achieve a good sound in your mixes.
Luck