1. Install drivers 2. Connect scan tool to the PC 5. Install OBDwiz software
Insert the software CD in your CD-ROM drive. If the drivers were successfully installed, the Click on OBDwiz, and follow the prompts to The scan tool selection menu will automatically status light should turn yellow when you connect install the software:appear. Click on OBDLink SX: OBDLink SX to your PCs USB port (step ). Red
status light indicates that USB drivers were not installed properly.
6. Launch OBDwiz software
To launch the software, click on Startg ProgramsgOBDwizgOBDwiz. The license key can be found on the CD case. Click the Auto 3. Locate the diagnostic connectorDetect button, then click the Connect button.
The software selection menu will appear. Click on Should you run into problems, technical support the driver link for your operating system and is just a click away:install the drivers:
Knowledgebase - contains answers to the most commonly asked questions, general information about OBD-II, and troubleshooting information.
Forum - allows you to share information 4. Connect scan tool to the DLCand get support from other OBDLink SX
Turn the vehicles ignition to the Key On, Engine users.Off position and connect OBDLink SX to the
These resources can be accessed from our diagnostic connector (step ). The status light website: should turn green. Yellow status light means no power on DLC; check fuses.
If the menu does not appear, click StartgRun, type D:\setup.exe (where D is the drive letter of your CD-ROM drive), and click OK.
The 16-pin D-shaped diagnostic link connector (DLC) should be located in the passenger or driver's compartment in the area bounded by the driver's end of the instrument panel to 300 mm (~1 ft) beyond the vehicle centerline, attached to the instrument panel and easy to access from the driver's seat. The preferred location is between the steering column and the vehicle centerline.
USB cablescan tool
Page 1Page 2