1
The Toggle Hook device is used to secure an engraved die onto a honeycomb chase. This device is perfect for many different foil stamping and embossing applications including close register jobs. The Toggle Hook’s locking action incorporates a combined forward and downward travel that grips and clamps the engraved die firmly into place. Because of the Toggle Hook’s locking action a 10˚ bevel is required on the outside edge of the engraved die to ensure a secure lock-down. Narrow Margin Toggle Hook. Used when there is less than 1/8” margin. Toggle Hook. This is the industry standard toggle hook and is used on most applica- tions. Toggle Hook. This toggle hook is designed for applications where hole choice is limited and the Standard No. 1 Toggle Hook will not reach the engraved die. Low-Jaw Toggle Hook. A similar toggle hook to the Standard No. 1 Toggle Hook except that its jaw thickness is 1/32“. This toggle hook is ideal for applications when the Standard Toggle Hook is locking-up on top of the die opposed to the side, where it ideally should lock. Extended Jaw Toggle Hook. This toggle hook has a jaw size of 5/16”. It is most commonly used on embossing/debossing applications. Extra Extended Jaw Toggle Hook. This larger jaw is helpful when locking-up engraved dies that extend over the chase bar. # 0 # 1 # 2 #3 # 3E # 4 0 1 2 3 3E 4 Sizes of Toggle Hooks Toggle Hooks

Toggle Hooks

Embed Size (px)

DESCRIPTION

kluge

Citation preview

  • The Toggle Hook device is used to secure an engraved die onto a honeycomb chase. This device is perfect for many different foil stamping and embossing applications including close register jobs. The Toggle Hooks locking action incorporates a combined forward and downward travel that grips and clamps the engraved die firmly into place. Because of the Toggle Hooks locking action a 10 bevel is required on the outside edge of the engraved die to ensure a secure lock-down.

    Narrow Margin Toggle Hook. Used when there is less than 1/8 margin.

    Toggle Hook. This is the industry standard toggle hook and is used on most applica-tions.

    Toggle Hook. This toggle hook is designed for applications where hole choice is limited and the Standard No. 1 Toggle Hook will not reach the engraved die.

    Low-Jaw Toggle Hook. A similar toggle hook to the Standard No. 1 Toggle Hook except that its jaw thickness is 1/32. This toggle hook is ideal for applications when the Standard Toggle Hook is locking-up on top of the die opposed to the side, where it ideally should lock.

    Extended Jaw Toggle Hook. This toggle hook has a jaw size of 5/16. It is most commonly used on embossing/debossing applications.

    Extra Extended Jaw Toggle Hook. This larger jaw is helpful when locking-up engraved dies that extend over the chase bar.

    # 0

    # 1

    # 2

    #3

    # 3E

    # 4

    0 1 2 3 3E 4

    Sizes of Toggle Hooks

    Toggle Hooks