uol thesis tempt (1).docx

7/31/2019 uol thesis tempt (1).docx

1/17

TITLE OF THESIS REPORT(Binding page)

Hasan Javed

Shehzad Miraj

Farukh BashirHafiz Umair Manzoor

Junaid Jafar

BME01083115

BME01083062

BME01083059BME01083063

BME01083096

Project Supervisor

Engr. Imran Mughal

DEPARTMENT OF MECHANICAL ENGINEERING

UNIVERSITY OF LAHORE,

1-Km, Raiwind Road Lahore

July, 2012


2/17

NOTE: Writings in GREEN are for your instructions.

This is only for your help; do not include this page in your thesis. This is only for side binding

instructions.

BSc. Mech. Eng.

(at top of close side of binding)

Title of Thesis Report in Vertical Direction

(in middle)

2012

(year of thesis submission

at bottom of close side of binding)

(Sample example is given on next page)


3/17

BSc.

Mech.

Eng.

2012


4/17

TITLE OF THESIS REPORT

(First page inside binding)

Hasan Javed

Shehzad Miraj

Farukh Bashir

Hafiz Umair Manzoor

Junaid Jafar

BME01083115

BME01083062

BME01083059

BME01083063

BME01083096

Project Supervisor

Engr. Imran Mughal

DEPARTMENT OF MECHANICAL ENGINEERING

UNIVERSITY OF LAHORE,

1Km, Raiwind Road Lahore

July, 2012


5/17

Note: Do NOTuse prefixes Sir or Mr. with supervisor name. Either writeEngr. orProf. Dr. as per according the rank of your supervisor.


6/17

i

ABSTRACT_________________________________________________________________

This paper reports the design, construction and testing of a parabolic

trough solar steam generator. Using concentrating collector, heat from the

sun is concentrated on a black absorber located at the focus point of the

reflector in which water is heated to a very high temperature to form

steam. It also describes the sun tracking system unit by manual tilting of

the lever at the base of the parabolic trough to capture solar energy. Thewhole arrangement is mounted on a hinged frame supported with a slotted

lever for tilting the parabolic trough reflector to different angles so that the

sun is always directed to the collector at different period of the day. On the

average sunny and cloud free days, the test results gave high temperature

above 200C.


7/17

ii

UNDERTAKING

Use the following undertaking as it is.

I certify that research worktitled enter title of your thesis report here is my/our

own work. The work has not, in whole or in part, been presented elsewhere for

assessment. Where material has been used from other sources it has been properly

acknowledged/ referred.

Signature of Student

Name of Students (Reg #)


8/17

iii

ACKNOWLEDGEMENTS

Write acknowledgment here. Use Times New Roman 12, Italic, justified.


9/17

iv

TABLE OF CONTENTS

Note: Below is a sample of Table of contents. You may exclude above contents or

include any further details according to your research. Please generate a Table of

content; dont create it manually:

Abstract ................................................................................................................i

Undertaking ...ii

Acknowledgement .......................................................................................................... iii

Table of Contents .vi

List of Figures ................................................................................................................... vList of Tables ................................................................................................................. vii

Abbreviations ................................................................................................................ viii

Chapter I: Introduction1.1 Statement of the Problem ......................................................................................... 1

1.1.1Subheading 1.2

1.1.2Subheading 2.3

1.2 Objectives ................................................................................................................. 4

1.2.1Subheading 1.5

1.2.2Subheading 2.6

1.3 Need or Motivation for the project i.e. why this project was needed and whatwas problem in the existing work

1.4 Organization of the Thesis ....................................................................................... 7

1.5 Deliverable.....8

Chapter II: Literature Review... ......................... 9

Must contain all the work done so far in the field. Containing Research papers,

book material e.t.c.

Chapter III: Methodology

a) Brief description of how research will be conducted.b) Experimentation.c) Experimental set up.d) Theoretical Studies.e) Results expected and method of the Analysis.

f) Utilization of Research


10/17

v

The results of the implementation/Simulation discussed in chapter III. It can have

graphs/ Screen Shoots of the results, Packet Traces, Images etc. It is also important

to discuss the scenario in which the experiment was conducted including theassumptions made during this process and data set taken.

Chapter IV: Conclusion and Future work

References..

Glossary ..


11/17

vi

LIST OF FIGURES

Sample is given below:

Number Page

Fig 2.1 Diagrams .........................................................................................................8

Fig 2.2 Graphs ..............................................................................................................9

Fig 2.3 Pictures/Scree shots .......................................................................................10


12/17

vii

LIST OF TABLES

Similar to the list of figures


13/17

viii

ABBREVIATIONS

Sample is given below:

ASME: American Society for Mechanical Engineers

TIG: Tungsten Inert Gas

UOL: University of Lahore


14/17

Chapter xyz

Thesis Title 9

CHAPTER 1:

Name of Chapter

1.1 Heading 1Enter Text here. Times New Roman 12, Regular, justified.

1.1.1 Subheading 11.1.1.1 Subheading 2

1.2 Heading 2


15/17

Chapter xyz

Thesis Title 10

CONCLUSION

Write conclusion of your thesis here. Maximum of 1 page


16/17

Chapter xyz

Thesis Title 11

REFERENCES

4. any WebSites

Note about Binding:

Three bound copies of the thesis report are to be submitted for examination. Hard

bound means permanently stitched and bound in BLACK cover with the title of

the thesis and your name (s) clearly printed on the cover as per format given at the

binding page of format in GOLDEN color.


17/17

Chapter xyz

Thesis Title 12

General Instructions:

Do not include irrelevant details in Thesis Report just to make reportlengthy. Be precise and to the point

Documents

uol thesis tempt (1).docx