All Information, Including Photos And Illustrations, In These Pages Is Believed To Be Correct And Reliable. The Information Contained In These Pages Is Given As General Information For The Installation Of Audio, Video, Security, Communications,And Other Accessory Products Into Mobile And/Or Vehicle Applications. The Install Doctor, Any Subsidiaries Or Divisions Thereof, Or Any Member Of These Companies Shall Not Be Held Liable For Any Damages And/Or Injuries Resulting From

The Use Of Information Contained In These Pages. All Information Contained In These Pages Should Be Checked And Verified With Appropriate Test Equipment To Assure The Safety And Proper Operation Of Equipment Installed And The VehicleItself. Careful Attention Should Be Given To All Electronic/Electric Circuits. High Voltages And Currents Can Cause Bodily Injury, Skin Damage, And Even Death. Installs Are Taken At The Risk Of Each Installer, And/Or Individual.

Publication, Duplication, or Retransmission Of This Document Not Expressly Authorized In Writing By The Install Doctor Is Prohi bited. Protected By U.S. Copyright Laws. © 1997,1998,1999,2000.

www.installdr.com

Majority Of Vehicles

Chrysler-Dodge Radio Wire Harnesses

Note: using an optional snap on wire harness adapter will simplify the wiring. Most snap on wire harness adapters have already converted and color codedthe wires from the auto makers in dash wire harness to match typical aftermarket radio wire colors.

** The wire colors listed in the chart above are typical for these vehicles during these years but may not be the exact colors for this vehicle. This is anotherreason to use a snap on wire harness adapter. **

AS VIEWED FROM MATING END OF CONNECTOR

A B C D E F G

H I J K L M N

Black Plug

Gray Plug

Typical Dodge/Chrysler Typical New RadioPin What It Is In Dash Wire Color Equivalent Wire Color

A Right Rear Spkr (-) Blue w/ White Stripe Purple w/ Black StripeB Left Rear Spkr (-) Brown w/ Yellow Stripe Green w/ Black StripeC Right Front Spkr (+) Purple GrayD Left Front Spkr (+) Dark Green WhiteE Right Rear Spkr (+) Blue w/ Orange Stripe PurpleF Left Rear Spkr (+) Brown w/ Blue Stripe GreenG Power Antenna/Amp White (use for Infinity Radio) BlueH +12 Volt Battery Wire Pink or Pink w/ White Stripe YellowI +12 Volt Ignition Wire Red w/ White Strip RedJ Radio Dimmer Wire Do Not UseK Headlight Dimmer Wire Do Not UseL Right Front Spkr (-) Blue w/ Red Stripe Gray w/ Black StripeM Left Front Spkr (-) Brown w/ Red Stripe White w/ Black StripeN No WireMetal Braid Or Plastic Connector Attached To Back Of Radio Is The Ground Wire

Black (see TIP)

If your original radio had a braided strap bolted to the rear of the radio.

If your original radio had a plastic connector containing a single wire plugged into the rear of the radio.

If your original radio or speaker grills were labeled or marked with ‘INFINITY’

Crimp a ring terminal to the new radios ground wireand insert a bolt through both connectors to connectthe ring terminal of the braided ground wire to thering terminal attached to the new radios ground wire.

TIP:

Crimp a male tab spade to the new radiosground wire. Slide it into the female tab spadeconnector that had originally snapped into therear of the factory radio.

TIP:

Crimp a male tab spade to the new radiosground wire. Slide it into the female tab spadeconnector that had originally snapped into therear of the factory radio to ground the Infinityamp and activate the ‘Infinity’ sound system.

TIP:

All Information, Including Photos And Illustrations, In These Pages Is Believed To Be Correct And Reliable. The Information Contained In These Pages Is Given As General Information For The Installation Of Audio, Video, Security, Communications,And Other Accessory Products Into Mobile And/Or Vehicle Applications. The Install Doctor, Any Subsidiaries Or Divisions Thereof, Or Any Member Of These Companies Shall Not Be Held Liable For Any Damages And/Or Injuries Resulting From

The Use Of Information Contained In These Pages. All Information Contained In These Pages Should Be Checked And Verified With Appropriate Test Equipment To Assure The Safety And Proper Operation Of Equipment Installed And The VehicleItself. Careful Attention Should Be Given To All Electronic/Electric Circuits. High Voltages And Currents Can Cause Bodily Injury, Skin Damage, And Even Death. Installs Are Taken At The Risk Of Each Installer, And/Or Individual.

Publication, Duplication, or Retransmission Of This Document Not Expressly Authorized In Writing By The Install Doctor Is Prohi bited. Protected By U.S. Copyright Laws. © 1997,1998,1999,2000.

www.installdr.com

2-pc Joint Production Vehicles

Chrysler-Mitsubishi Radio Wire Harnesses

Note: using an optional snap on wire harness adapter will simplify the wiring. Most snap on wire harness adapters have already converted and color codedthe wires from the auto makers in dash wire harness to match typical aftermarket radio wire colors.

** The wire colors listed in the chart above are typical for these vehicles during these years but may not be the exact colors for this vehicle. This is anotherreason to use a snap on wire harness adapter. **

AS VIEWED FROM MATING END OF CONNECTOR

C D

A B

H I

F G

E K

J

N

M

L

Mitsubishi-Chrysler Corp Typical New RadioPin What It Is In Dash Wire Color Equivalent Wire Color

A Right Front Speaker (+) Two White w/ Red Stripe GrayB Right Rear Speaker (+) Yellow w/ Red Stripe PurpleC Do Not UseD Left Front Speaker (+) Two White w/ Blue Stripe WhiteE Left Rear Speaker (+) Yellow w/ Blue Stripe GreenF Light Dimmer WireG Headlight IlluminiationH +12 Volt Battery Wire Red w/ Black Stripe YellowI +12 Volt Ignition Wire Blue RedJ Left Rear Speaker (-) Gray w/ Blue Stripe Green w/ Black StripeK Right Rear Speaker (-) Gray w/ Red Stripe Purple w/ Black StripeL Power Antenna Turn On BlueM Left Front Speaker (-) Two Black w/ Blue Stripe White w/ Black StripeN Right Front Speaker (-) Two Black w/ Black Stripe Gray w/ Black StripeNOTE: this vehicle does not have a (-) Ground Wire attached to either connector. Theradio grounds when the metal brackets attached to the radio screw into the metal dashor the ground wire from the new radio is screwed into metal of the vehicles dash.

AS VIEWED FROM MATING END OF CONNECTOR

D E F G K L M

A B C H I J

If your original radio had a metal female connector attached to a single wireplugged into the rear of the radio.

Crimp a male tab spade to the new radiosground wire. Slide it into the female tab spadeconnector that had originally snapped into therear of the factory radio.

TIP:

Jeep-Chrysler 1pc. Radio Wire HarnessesTypical Jeep Typical New Radio

Pin What It Is In Dash Wire Color Equivalent Wire Color

A Right Rear Spkr (-) Blue w/ Orange Stripe Purple w/ Black StripeB Right Front Spkr (-) Blue w/ Red Stripe Gray w/ Black StripeC Do Not UseD Right Rear Spkr (+) Blue w/ White Stripe PurpleE Right Front Spkr (+) Purple GrayF +12 Volt Ignition Wire Lite Purple w/ White Stripe RedG +12 Volt Battery Wire Pink YellowH Do Not UseI Left Front Spkr (-) Brown w/ Red Stripe White w/ Black StripeJ Left Rear Spkr (-) Brown w/ Blue Stripe Green w/ Black StripeK Do Not UseL Left Front Spkr (+) Green WhiteM Left Rear Spkr (+) Brown w/ Yellow Stripe Green