Production of Content page

This is how I went onto to construct my contents page and how I edited each picture

I firstly opened up a new page

I then went on to edit my photos separately before gathering them all together

EDDITING PICTURE 1 - T o edit this picture I first had to remove the pipe from the wall this was achieved by using the cloning stamp tool followed by the smudge tool.

Before After

I then went on to add a gradient overlay and add a glow around the image

Final image

EDDITING PICTURE 2 - After importing the image into Photoshop I then proceeded to edit this picture by going to image adjustment and selecting pasteurize which relates the effect seen, I had the options to increase or decrease how much I wanted to pasteurize the image.

Before After

I have also remover the table from the background i did this annishaly by using the crop tool and the clone stamp.

EDDITING PICTURE 3-To didn’t this picture I added a filter the filter I finally applied was a brush stroke, this gave the appearance that the photo had infract been painted.

Before After

I then added a glow around the image so it can match with the other images on the page, the glow will also help the image to stand out.

EDDITING PICTURE 4- I cut this image out using the lasso tool after cutting it I then copied it onto another page and started to work on the painting also before cutting the image I set the feather to 2 to avoid getting any sharp lines.

After cutting this image I then went on to cut the image of the frame I did this using the magic wand tool as it give me nice neat straight line.

After doing this I pit both images onto of each other after skewing them to ensure they looked as if I took the image like that to begin with. After which I used the brush tool to create lines in the hairy to make parts of the painting visible to give the effect she has been scratched in.

One the layers were merged I went on to create an effect so it appeared as if the image of the girl was painted into the image behind. To create this I used the rubber tool where I selected a different brush .

After

Adding a signature

First i wrote out my signature on paper and took a picture of it.

I then went on to crop this thotop on photoshop.

After doing this i then imported this image onto my content page where i adujested its size. i also used the magic wand tool to errase the gray ares giving the effect it was written on the page itself.

After fully reeaing the background of the image,I then went onto to adjust the brightness and contrast of the image, i did this by going to image adjustment brightness to help it to stand out more.

Finial Contents Page