View
212
Download
0
Category
Preview:
Citation preview
7/31/2019 00887715
1/3
IEEE PHOTONICS TECHNOLOGY LETTERS, VOL. 12, NO. 11, NOVEMBER 2000 1501
Novel Flat Multichannel Filter Based on StronglyChirped Sampled Fiber Bragg Grating
Xiang-fei Chen, Chong-cheng Fan, Y. Luo, Shi-zhong Xie, Senior Member, IEEE, and S. Hu
AbstractIn this letter, a novel optical fiber filter basedon a strongly chirped sampled Bragg grating is proposed forwavelength-division-multiplexing (WDM) system applications. Itfeatures in multiple equalized passbands with flat-top steep-edgenearly linear phase response and high transmittance. Refractiveindex modulation amplitude with Gaussian spatial profile is usedwithin the samples, which contributes to the marked improvementof the filter performance. Furthermore, there are also multipleflat and equalized stopbands to be used as multichannel opticaladd/drop filters in WDM system.
Index TermsGratings, optical fiber communication, opticalfiber devices, optical fiber dispersion, wavelength-division-multi-plexing (WDM).
I. INTRODUCTION
MUCH attention has been drawn to the design andimplementation of compact optical devices for wave-length-division-multiplexed (WDM) systems. Among them,
multichannel transmission filters based on grating principle are
of special importance. For example, a Moir grating (MG) is
a special grating with two superimposed gratings at different
wavelengths. Usually, when a large chirp in the grating period
is included, multiple passbands may result in such a chirped
Moir grating (CMG) [1], which can be used as a multichannel
transmission filter. However, passbands of this structure are
Lorenzian with sharp peaks and broad-bottom areas. A carefuldesign by embedding some fiber sections with no refractive
index modulation in a CMG has been proposed to overcome
this disadvantage [2], [3]. Furthermore, non-Lorenzian but
rippled passbands may exist in a chirped super Moir grating
(CSMG), which is a special MG with multiple ( 2) superim-
posed chirped gratings at different wavelengths. Anyway, few
literatures discuss CSMG due mainly to the difficulties in its
precise fabrication.
On the other hand, sampled Bragg gratings (SBG) have
attracted much attention for their compactness and potential
application in WDM systems such as multichannel filtering,
multichannel optical add/drop multiplexing [4], [5] and dis-
persion compensation [6]. In this letter, we show that a SBG
Manuscript received May 23, 2000; revised June 30, 2000. This work wassupported by the Fundamental Research Foundation, School of the InformationScience and Technology, Tsinghua University, and the Foundation for VisitingScholar, State Key Labs, State Education Commission. This work was also sup-ported in part by the 863 High Tech Foundation under Contract 863-307-11-3(02) and the Natural Science Foundation of China under Contracts 69525407and 69896260-1.
The authors are with the Information Optoelectronic Technology ResearchInstitute (IOTRI) and State Key Lab on Integrated Optoelectronics, Departmentof Electronic Engineering, Tsinghua University, Beijing 100084, China.
Publisher Item Identifier S 1041-1135(00)09584-7.
can be regarded as an equivalent super Moir grating (SMG)
[6], [7]. When the grating period of SBG is strongly chirped,
multiple passbands with small ripples may appear. It is shown
that, when the distribution of the refractive index modulation
amplitude within the sample is Gaussian, the performance of
the proposed filter can be improved intrinsically: flat top with
very small ripple in peak transmittance, steep edge and nearly
linear phase response. Furthermore, the proposed device can
also have multiple flat equalized stopbands that may facilitate
the design and application of multichannel optical add/drop
multiplexers (OADM).
II. PERFORMANCE OF THE PROPOSED DEVICE
A SBG is a Bragg grating modulated by a periodic sampling
function. In terms of Fourier analysis, it can be treated as an
equivalent SMG with multiple superimposed ghost gratings [6].There are multiple stopbands corresponding to superimposed
ghost gratings and also multiple reflection peaks. When a SBG
is chirped in grating period (CSBG), all ghost gratings in the
structure are chirped with identical chirping coefficient. The
chirp of CSBG can be expressed as
(1)
wheregrating period along the structure;
grating period at the center of the grating;
chirping coefficient;
length of SBG.
When the chirp is weak, the stopbands are not overlapped, light
incident to theSBG is affectedonly by oneghost grating. In such
a situation, there is no resonance transmission in the structure.
However, when the chirp is strong, the stopbands are widely
broadened and several neighboring stopbands related to the cor-
responding ghost gratings may be overlapped. Incident light
with wavelength located within the overlapped region will be
affected by several ghost gratings, and may transmit through the
CSBG without impediment. Therefore, when the chirp is strongenough, there may be multiple passbands in such a CSBG. It is
should noted that passbands produced by the resonance related
to multiple superimposed gratings (not two superimposed grat-
ings in CMG); that is to say, the optical response in a CSMG is
the interference of the response of multiple CMGs. In such a
situation, the passbands are non-Lorenzian. The passbands can
be flat (with small ripples) as shown in Fig. 1(a), where the
sample number , sampling ratio (sample length di-
vided by sampling period) , mm and
m. The average refractive index of the grating is
10411135/00$10.00 2000 IEEE
http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-7/31/2019 00887715
2/3
1502 IEEE PHOTONICS TECHNOLOGY LETTERS, VOL. 12, NO. 11, NOVEMBER 2000
Fig. 1. Transmission spectrum of a strongly chirped sampled Bragg gratingmm, mm , , . (a)and . (b) and .
1.485. Please note the index modulation amplitude is constant
in each sample.
In order to further improve the filter performance (further re-
duce the ripple), a Gaussian, rather than constant, spatial profile
of the refractive index modulation amplitude is applied within
each sample
(2)
where
refractive index modulation amplitude within
each sample;
and parameters;
sample length (in the order of millimeter).
Performance of the proposed CSBG filter is shown in Fig. 1(b)
for . In Fig. 2, a peak from Fig. 1(b) is replotted, showing
flat passbands with very small ripples, steep edges and high
transmittance.
The phase response of CSBG is also investigated, wherein the
group delay of the filter is also plotted in Fig. 2, showing verysmall variance. This means that the dispersion in the passbands
is nearly zero.
As an example, a CSBG appropriate for 32-channel filtering
with 50-GHz channel spacing is shown in Fig. 3. The averaged
transmittance is 99.7% and the ripple is less than 0.1 dB. The
0.1 dB, 3 dB, and 20 dB bandwidths are 0.23, 0.27, and
0.31 nm, respectively. Although similar performance of pass-
bands can be obtained with the idea shown in [ 2], there are
some distinct differences in between: 1) mechanismthe CSBG
proposed by this work is based on an equivalent CSMG, not
a CMG [2], consequently the passbands is intrinsically non-
Lorenzian; 2) channel spacingin CSBG, the spacing between
Fig. 2. Transmittance (solid line) and group delay (dotted line) of a peak inFig. 1(b).
Fig. 3. Transmission spectra of a strongly chirped sampled Bragg gratingmm, mm , , , , and
.
neighboring passbands can be precisely controlled because it
varies with the sampling period, which is in the order of mil-
limeters; 3) fabricationCSBG can be fabricated by single ex-
posure of a single linearly chirped phase mask [6], not by dual
exposure [1][3]. Furthermore, the bandwidth of the passbandscan be individually adjusted by the parameter . All these fea-
tures will facilitate the applications of CSBG in WDM systems.
Low-cost and high-performance grating filters with multiple
reflection wavelengths is also important for OADM applica-
tions. In an unchirped or lightly chirped SBG, the dispersion is
large in the stop-band edge although the filter performance can
be almost identical between channels with careful design [8].
This disadvantage can be minimized in a strongly chirped SBG,
which can be seen in Fig. 4. The filter performance is near-iden-
tical among channels. Fig. 5 shows an enlarged view of a stop
band as well as its group delay. In addition to nearly flat spec-
trum response, the in-band difference of the group delay is less
http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-http://-/?-7/31/2019 00887715
3/3
CHEN et al.: MULTICHANNEL FILTER BASED ON STRONGLY CHIRPED SAMPLED FIBER BRAGG GRATING 1503
Fig. 4. Reflection spectrum of a strongly chirped sampled Bragg gratingmm, , mm , , , and
.
Fig. 5. Reflectance (solidline)and groupdelay(dotted line) ofa peak in Fig. 4.
than 30 ps. These features can be used to fabricate high-per-
formance multichannel add/drop multiplexer filters for WDM
applications.
III. CONCLUSION
In this letter, we have proposed a novel multichannel trans-
mission filter based on a strongly CSBG. The principle is re-
lated to an equivalent CSMG mechanism and is different from
published works. By simply chirping a conventional SBG that
can be fabricated with a single exposure of a single linearly
chirped phase mask, passbands with small ripples can be ob-tained. When the spatial profile of the refractive index modula-
tion amplitude within each sample is Gaussian, the performance
of the proposed filter is improved: nearly flat passbands with
very small ripples in peak transmittance, steep edges, nearly
linear phase responses and high transmittance. Similar flat stop-
bands can also be obtained in the proposed device. With shorter
length and fewer number of samples, the proposed device can
be used as multichannel filters and multichannel OADM filters
in WDM systems.
REFERENCES
[1] L. A. Everall, K. Sugden, J. A. R. Williams, I. Bennion, X. Liu, J.S. Aitchison, S. Thomas, and K. M. DelaRue, Fabrication of multi-passband moire resonators in fibers by the dual-phase-mask exposuremethod, Opt. Lett., vol. 22, pp. 14731475, 1997.
[2] L. R. Chen, D. J. E. Cooper, and P. W. E. Smith, Transmission fil-ters with multiple flattened passbands basedon chirped Moire gratings,
IEEE Photon. Technol. Lett., vol. 10, pp. 12831285, Sept. 1998.[3] L. R. Chen, D. J. E. Cooper, P. W. E. Smith, R. Tam, and X. Gu, Fabri-
cation of transmission filters with single or multiple flattened passbandsbased can chirped Moire gratings, Electron. Lett., pp. 584585, 1999.
[4] J. Hubner, D. Zauner, and M. Kristensen, Strong sampled Bragg grat-ings for WDM applications, IEEE Photon. Technol. Lett., vol. 10, pp.552554, Apr. 1998.
[5] W. H. Loh, F. Q. Zhou, andJ. J. Pan, Noveldesignsfor sampled grating-based multiplexers-demultiplexers, Opt. Lett., vol. 24, pp. 14571459,
1999.[6] F. Ouellette, P. A. Krug, T. Stephens, G. Dhosi, and B. J. Eggleton,
Broadband and WDM dispersion compensation using chirped sampledfiber Bragg gratings, Electron. Lett., vol. 31, pp. 899901, 1995.
[7] X.-f. Chen, Z.-b. Ma,, W.-h. Li, X.-n. Yin, and Z.-j. Wu, Super chirpedMoir grating based on acousto-optical superlattice using chirped fiberBragg grating, Opt. Lett., vol. 24, pp. 15581560, 1999.
[8] M. Ibsen, M. K. Durkin, M. J. Cole, and R. I. Laming, Sinc-sampledfiber Bragg gratings for identical multiple wavelength operation, IEEEPhoton. Technol. Lett., vol. 10, pp. 842844, June 1998.
Recommended