1. EXTERIOR LAMP SYSTEM LAYOUT -...

01-30000-00

Turn signal lamp

Side repeater lamp

Puddle lamp

1. EXTERIOR LAMP SYSTEM LAYOUT

Headlamp (High beam)

Tail lamp, DRL (EU)*

Front fog light

Tail lamp

High-mounted stop lamp

Stop lamp

License plate lamp

Turn signal lamp

Stop lamp, Rear fog light (EU)

Reflector

Front view

Rear view

Headlamp (Low beam)

Back-up lamp

01-4

Headlamp

Puddle lamp

Front fog light

Side repeater

Turn signal lamp

Headlamp(High beam)

Headlamp(Low beam)

Tail lamp, DRL (EU)*

01-50000-00

High mounted stop lamp

License plate lamp

Rear combination lamp

Vehicle with spoiler Vehicle without spoiler

Back-up lamp

Stop lamp

Tail lamp

Turn signal lamp

Stop lamp, Rear fog light (EU)

01-6

Front room lamp

Glove box lamp

Sun visor lamp

2. INTERIOR LAMP SYSTEM LAYOUT

01-70000-00

Luggage lamp Door courtesy lamp

Center room lamp

01-8

Hazard warning switch bezel assembly

Drive door main switch & Outside rearview mirror

switchFATC switch

Steering wheel remote control switch

Passenger door switch

Lower main panel switch

Start/stop switch

Cruise control switch

Multifunction switch

3. SWITCH SYSTEM LAYOUT

01-90000-00

Luggage lamp switch

Overhead console switch

Front seat heating and ventilation switch

With heating and ventilation switch With heating switch

Driver power seat switch

Center room lamp switch

Rear door switch (RH) Rear door switch (LH)

Tailgate switch

01-10

4. SCHEMATIC DIAGRAM FOR WIRING AND ELECTRICAL DEVICES1) Wiring Harness Arrangement

01-110000-00

2) Electrical Devices Mounting Locations

01-12

3) Connector, Ground And Splice PackConnector▶

01-130000-00

Ground▶

Splice pack▶

01-14

5. CAN COMMUNICATION CONFIGURATIONThe CAN topology is linked with CAN communication system, which consists of P-CAN and B-CAN. The instrument cluster and BCM (Body Control Module) communicate through both P-CAN and B-CAN at the same time, and the SKM (SMART Key Module) communicates with the instrument cluster and BCM through B-CAN.

1) CAN Configurations (P-CAN/B-CAN)

Abbreviations Meaning Function

GCU Glow Control Unit Glow Control Unit

EPS Electronic Power Steering Unit Electronic Power Steering Unit

BCM Body Control Module Body Control Module

SKM Smart Key Module Smart Key Module

TPMS Tire Pressure Monitering System Tire Pressure Monitering System

01-150000-00

2) CAN Communication Wiring Diagram

Splice pack Wiring Location

S101 W/H Floor (LH) Glow Control Unit

S102 W/H Floor (RH) Inside RH Fender

S202 W/H Main Backside Cluster (LH Cowl Cross Member)

S204 W/H Main Backside Cluster (Under ICM Relay Box)

S205 W/H Main Backside Audio (CTR Cowl Cross Member)

S206 W/H Floor (LH) Under Driver Seat

S401 W/H Floor (LH) Beside PAS Unit (inside LH QTR Trim)