View
213
Download
0
Category
Preview:
Citation preview
7/27/2019 6-Production From Two Phase Reservoirs
1/10
Production from Two-phase Reservoirs:
- Phase diagram- Gas oil ratio in saturated reservoirs- Properties of two phase fluids, relative permeability
- Comparing single and two phase flowsSteady statePseudo steady state
- Inflow performance relationship (IPR)Single phase flowTwo phase flow
Vogels correlationsGeneralized Vogels correlationsFetokovichs approximation
Earlier flow relationships have considered only single-phase flow of oil. The effect
of simultaneously producing liquid (oil) and gas on the liquid flow rate will now be
considered.
7/27/2019 6-Production From Two Phase Reservoirs
2/10
(From, Dake, Fundamentals of Reservoir Engineering)
If the reservoir is below bubble point pressure, as depicted in fig. 2.1(b), the situation ismore complicated. Now there are two hydrocarbon phases in the reservoir, gas saturatedoil and liberated solution gas. During production to the surface, solution gas will be
evolved from the oil phase and the total surface gas production will have twocomponents; the gas which was free in the reservoir and the gas liberated from the oilduring production. These separate components are indistinguishable at the surface and theproblem is, therefore, how to divide the observed surface gas production into liberatedand dissolved gas volumes in the reservoir.
In a saturated reservoir each stock tank barrel of oil is produced in conjunction with R scfof gas, where R (scf/stb) is called the instantaneous or producing gas oil ratio and ismeasured daily (see fig 2.3). As already noted, some of this gas is dissolved in the oil inthe reservoir and is released during production through the separator, while the remainderconsists of gas which is already free in the reservoir. Furthermore, the value of R can
greatly exceed Rsi, the original solution gas oil ratio, since, due to the high velocity ofgas flow in comparison to oil, it is quite normal to produce a disproportionate amount ofgas. This results from an effective stealing of liberated gas from all over the reservoir andits production through the relatively isolated offtake points, the wells. A typical plot of Ras a function of reservoir pressure is shown as fig. 2.4.
7/27/2019 6-Production From Two Phase Reservoirs
3/10
The producing gas oil ratio can be split into two components as shown in fig. 2.3, i.e.R = Rs +(R-Rs)The first of these, Rs scf/stb, when taken down to the reservoir with the one stb of oil,will dissolve in the oil at the prevailing reservoir pressure to give Bo rb of oil plusdissolved gas. The remainder, (R -Rs) scf/stb, when taken down to the reservoir willoccupy a volume
and therefore, the total underground withdrawal of hydrocarbons associated with theproduction of one stb of oil is(Underground withdrawal)/stb = Bo + (R Rs) Bg (rb/stb)
The shapes of the Bo and Rs curves below the bubble point, shown in fig. 2.5(a) and(b), are easily explained. As the pressure declines below pb, more and more gas isliberated from the saturated oil and thus Rs, which represents the amount of gas dissolvedin a stb at the current reservoir pressure, continually decreases. Similarly, since eachreservoir volume of oil contains a smaller amount of dissolved gas as the pressuredeclines, one stb of oil will be obtained from progressively smaller volumes of reservoiroil and Bo steadily declines with the pressure.
7/27/2019 6-Production From Two Phase Reservoirs
4/10
7/27/2019 6-Production From Two Phase Reservoirs
5/10
7/27/2019 6-Production From Two Phase Reservoirs
6/10
The presence of a gas phase reduces the relative permeability of oil.
Relative permeabilities are laboratory-derived relationships, are functions of fluid
saturations and functions of specific reservoir rock.
The expansion of free gas creates an effective mechanism for the production of fluids.
The reservoir pressure, which is the driving force for the flow, decreases rapidly with
production from a reservoir containing liquid only.
7/27/2019 6-Production From Two Phase Reservoirs
7/10
Comparing the Flow Equations for Single and Two-phase Flows:
STEADY STATE INFLOW:
PSEUDO-STEADY STATE FLOW:
dpB
k
srr
hkq
e
wf
p
poo
ro
we
o +=
])/[ln(2.141
dp
B
k
Dqsrr
hkq
p
poo
ro
we
o
wf
++
=]
43)/[ln(2.141
)(])/[ln(2.141
wfe
we
opp
srrB
hkq
+
=
owfe
weoo
oo
ppsrrB
hkq )(
])/[ln(2.141
+=
)(]
4
3)/[ln(2.141
wf
we
o ppsrrB
hkq
+=
7/27/2019 6-Production From Two Phase Reservoirs
8/10
INFLOW PERFORMANCE RELATIONSHIP (IPR):
All well deliverability equations relate the well production rate and the driving force in
the reservoir, that is, the pressure difference between the initial, outer boundary or
average reservoir pressure and the flowing bottomhole pressure.
If the bottomhole pressure is given, the production rate can be obtained readily.
However, the bottomhole pressure is a function of the wellhead pressure, which, in turn,
depends on production engineering decisions, separator or pipeline pressures, etc.
Therefore, what a well will actually produce must be the combination of what the
reservoir can deliver and what the imposed wellbore hydraulics would allow.
It is then useful to present the well production rate as a function of the bottomhole
pressure. This type of presentation is known as an "inflow performance relationship"
(IPR) curve. Usually, the bottomhole pressure,pwf, is graphed on the ordinate and the
production rate, q, is graphed on the abscissa.
Pseudo steady state IPR calculation is the most useful and most commonly done
for the forecast of well performance. Each IPR curve reflects a snapshot of well
performance at a given reservoir pressure. This is time dependent calculation done in
discrete intervals. In combination with volumetric material balances it will allow the
forecast of rate and cumulative production versus time.
The complex analytical solutions to the two-phase flow equations will not be
considered in this course. The two-phase correlations of Vogel and Fetkovitch will
be presented.
]87.023.3)log()[log(6.162
2S
rc
kt
kh
Bqpp
wt
owfi ++=
])[ln(2.141
sr
r
hk
qBpp
w
ewfe +=
]4
ln2
1[
2.1412
srC
A
kh
qBpp
wA
wf +=
7/27/2019 6-Production From Two Phase Reservoirs
9/10
Vogel's Correlations:
Vogel developed a set of inflow performance relationship (IPR) correlations. The
particular correlation that is appropriate is dependent on the magnitude of the average
reservoir pressure,P
, and the wellbore pressure, Pwf, relative to the bubble-pointpressure, Pb. These correlations are valid for a wide range of reservoir and fluid
properties. Only the properties of the oil phase associated with the two-phase flow are
required for Vogel's correlations.
Case 1: Pwf< P Pb (original Vogel Correlation)
In this case there is two-phase flow throughout the reservoir:
o and B are evaluated at P .
7/27/2019 6-Production From Two Phase Reservoirs
10/10
Case 2: P > Pb but PbPwf (Vogel's Generalised Correlation)A limiting volumetric flow, qb, is defined which represents the flow that occurs in the
specific case when the wellbore pressure is equal to the bubblepoint pressure (P wf=Pb).
Fetkovitch Inflow Performance Relationship:
In some cases Vogel's correlations do not accurately represent well /reservoir
behavior. The correlation of Fetkovitch can also be applied to two-phase systems.
Fetkovitch developed an empirical equation based on two correlation parameters,
qo,max and n. To apply the correlation, well measurements must be performed during at
least two stable flow conditions. Fetkovich's equation is adjusted to fit to the data
using the parameters.
The following two equations are combined to give the final empirical equation:
Recommended