View
267
Download
1
Category
Preview:
Citation preview
AUTOCOM CDP PRO TRUCKS - 2011 Release 3 Operation manual
To finish the Autocom TRUCKS software update to 2011-3 version, you need to use two computers: one connected to internet for autocom activation and the other disconnected to internet for autocom installation. 1. Put the autocom CD into the computer that disconnected to internet and
run the “sart.exe’: 2. Select one language you want to install:
http://www.obdchina.com
3. Input the product id: a-710-254
http://www.obdchina.com
4. Input the S/N and Hardware Key for TRUCKS serial number: 39071, HW
key: PUKRJOIVQTYX
http://www.obdchina.com
http://www.obdchina.com
5.
http://www.obdchina.com
6. 7. Select the installation path and click “Next”:
http://www.obdchina.com
8. You could keep this information blank, click “Next” button: It will pop up new window to reminder you that you have not entered the information, just click “Yes”:
http://www.obdchina.com
http://www.obdchina.com
9. click “Install” button:
http://www.obdchina.com
http://www.obdchina.com
10. Click “Finish’ button to complete the autocom installation, select “Run application”, at this step, please don’t connect the autocom device:
http://www.obdchina.com
11. Run the autcom software installed, it will show this information, click the forward button:
http://www.obdchina.com
12. Click “activate via USB stick” button: 13. At this step, connect the USB stick at least 1MB free space to computer,
http://www.obdchina.com
then you will see second display: 14. The software is writing the FileActivation.xml and other information to USB stick. In the USB stick, you will see those files:
http://www.obdchina.com
You will see the display on software window, disconnect the USB stick from computer:
15. Post this FileActivation.xml file with reference number on the CD to support001@sinosells.com: Note : please send an FileActivation.xml file with reference number. i will not answer mail if haven't reference number. 16. Connect the USB stick to computer that is connected to internet for the new FileActivation.xml file. 17. You will get a new FileActivation.xml file from us, copy into USB-memory stick to overwrite the old one, or delete the old FileActivation file first and then copy the new file to USB stick. (Note: this step should be finished in that computer that is connected to internet). 18. Remove the USB stick from that computer which is connected to internet. 19. Reconnect the USB stick to this computer that is disconnected to internet, software will get information from USB stick automatically.
http://www.obdchina.com
20. If the program does nothing, click “manual mode”, click “open file” to select the activated file
21. Eject out usb-memory stick, software will open then will have an error (Failed to load vehicle ......), just close software 22. Run '' Update_3_-_2011_Release_3 '' , write product id ( for trucks : a-710-254 ) ,then software will open !! 23. If you used already old version autocom, for use interface you need make firmware update: Connect interface to truck. (For power) Select “setting”, do hardware test, it will have a message asking about firmware update. Click “ok” and it will make firmware update.
http://www.obdchina.com
You need wait few minute for firmware update. (When is doing firmware update, don’t close software or remove power, etc) Then you can use autocom 2011 release3!
http://www.obdchina.com
Recommended