Autonomous Ultrasonic Robot for Area...

A.U.R.A.S

Autonomous Ultrasonic Robot for

Area Scanning

Project Progress Report 2

ECE 511

Fall 2014

George Mason University

11/11/2014

Group: 2

Team Members:

Devaraj

Nikhila Kalinga

Gagandeep Singh Bamrah

Ankita Pandey

Block Diagram1(Handheld Controller)

Block Diagram 1(A.U.R.A.S)

Overall Status

All the required components have been acquired

Robot’s movement: DC Motors tested and interfaced with MSP430

Obstacle Detection: Ultrasonic sensor is tested and interfaced with MSP430

RF link (serial communication) is tested and interfaced successfully to MSP430

Movement Control

1). Autonomous control: Voice module is tested

2). Manual Control: Push buttons and Led Lights are tested and interfaced

INTERFACING ULTRASONIC SENSOR

WITH MSP430

P2.4 TriggerMSP 430

P2.5Echo

Progress: Acquired ,Tested and Interfaced

WORKING OF ULTRASONIC SENSOR

SPECIFICATIONS

•12 Volts DC

• 100 RPM

• Torque: 90 N*cm

ELECTRONIC MOTOR

• It will be used as a rear wheel

drive

INTERFACE:

• Input via MSP430 Pins: P1.2, P1.3, P1.4, P1.5

• H-bridge L293D to interface 5V MSP430 to

drive two 12 volts Electronic motors

PROGRESS:

Acquired, tested and interfaced

DC Motors

Inputs from Microcontrollers:

M1-B M1-A

M2-B M2-A

Enable Pins:

1-2 EN

3-4 EN

Output to 2 Motors:

1Y,2Y1Y,2Y

4Y,3Y

GND-1,2,3,4 connect to

microcontroller ground

H-Bridge: L293D

VOICE MODULE AND RF LINK

INTERFACING

NAME: Easy VR Speech Recognition

Module v2.0

PROGRESS: Acquired and tested with

Arduino Uno

CHALLENGE: To directly interface the

module to MSP430 through UART

interface (powered at 3.3V - 5V)

NAME: Transmitter Receiver Schematic

SPECIFICATION: Zigbee protocol is

used to interface 315 MHz RF links to

MSP430

PROGRESS: Successful transmission

and reception of data wirelessly.

INTERFACING OF MOTORS AND

ULTRASONIC SENSORS

INTERFACING OF PUSH BUTTONS

AND LED LIGHTS

THINGS TO BE DONE

• Interfacing Voice recognition module to

MSP430 directly through UART.

• Acquiring the chassis and mounting all the

components on it for building the carcomponents on it for building the car

BACK UP PLAN

• To interface voice module with Arduino Uno

and connect the input output pins to the ports

of MSP430.

Thank YouThank You