View
225
Download
0
Category
Preview:
DESCRIPTION
Design the block part that the finished product will be placed in
Citation preview
Chocolate Mold Design
Design your desired finished product part
Design the block part that the finished product will be placed in
In an assembly put the part into the block, centered on all three axis's
Place a point on the bottom face of the block and cut a counter-sunk hole into the block all the way to the part.
Place a work plane right through the middle of the part and block
“Split” the block removing the front half of the block, then save the part.
Undo the split and split it the other way and save that half too.
You are now ready for EdgeCAM
Recommended