CUT’HAZARD Supplied$cut$resistant$gloves$ … · Step$2$–...

Preview:

Citation preview

Handle  Replacement  Kit  – EK9288BMT-­‐80L

Kit  Contents: Two-­‐Piece  Black  Plastic  Protective  CollarNOTE:  DO  NOT  ASSEMBLE  THE  PARTS  AWAY FROM  THE  TRASH  CAN,  YOU  WILL  NOT  BE  ABLE  TO  SEPARATE  THEM  ONCE  THEY  ARE SNAPPED  TOGETHER.InstructionsCut  Resistant  Safety  Gloves

Prior  to  beginning  the  repair:

• Review  the  new  parts.  The  smaller  piece  is  the  outer  plastic  part,  the  larger  piece  is  the  inner  plastic  part.

• DO  NOT  ASSEMBLE  THE  PARTS  AWAY  FROM  THE  TRASH  CAN,  YOU  WILL  NOT  BE  ABLE  TO  SEPARATE  THEM  ONCE  THEY  ARE  SNAPPED  TOGETHER.

• BE  SURE  TO  WEAR  THE  SUPPLIED  SAFETY  GLOVES  WHILE  PERFORMING  THE  INSTALLATION.

A  video  of  the  installation  is  available  @  www.ekousaltd.com/80Linstallation

CUT  HAZARDSupplied  cut  resistant  gloves  

must  be  worn  when  performing  the  installation

Step  1  – Remove   the  one-­‐piece   black  plastic  protective  collar  as  detailed  below

1a.   Hold  the  handle  at  the  bottom  from  inside  of  the  trash  can  body

1b.   Lift  upwards  on  the  plastic  part

1c. Push  the  bottom  of  the  handle  from  inside  the  trash  can  body  until  in  can  be  pulled  out  from  the  outside  of  the  trash  can

1d. Remove  the  part  from  the  opening

Step  2  – Install  the  new  two-­‐piece  black  plastic  protective  collar  as  detailed  below

2a. Insert  the  smaller,  outer  plastic  piece  into  the  metal  cutout  on  the  outside  of  the  trash  can  body

Make  sure  each  of  the  6  clips  are  inside  the  outer  edge  of  the  trash  can  as  shown  in  the  photo  to  the  right.  The  outer  piece  will  then  be  temporarily  secured  to  the  trash  can  body.

2b. Attach  the  inner  plastic  piece  from  the  inside  of  the  trash  can  body  to  the  outer  piece

2c. Pinch  each  of  the  6  clip  points  until  they  snap  together,  securing  the  two  pieces  together

Recommended