View
227
Download
1
Category
Preview:
Citation preview
Designed for easy Installation, long lifetime and high efficiency. This high quality Australian designed LED driver delivers 650mA constant current at 12Vdc -16Vdc. The driver is suitable for dimming LED loads via standard phase controlled dimmers connected to the 240Vac/50Hz mains input.
Smooth dimming to levels as low as 1% via mains rated, phase angle controlled dimmers (dimmer dependent)
Open circuit / short circuit detection of dc output
Compatible with 3rd party LED lamps with suitable dc current / voltage specifications
Pre-terminated with Australian/NZ 240Vac 10A mains flex & plug
Cable strain relief for both mains and dc wiring
inside and outside luminaires
Overview
Range
Features
Dimensions
DGLC650C13PD
30 m
m
125 mm
45 m
m
45 mm
650mA 13W LED Driver Phase Dimmable
www.diginet.net.au
DIGINET CONTROL SYSTEMS DATA SHEET
Data Sheet DGLC650C13PD - Edition 01 Subject to change without notice. Latest updates available at www.diginet.net.au of 2 pages1
Suitable for installation
A MEMBER OF THE GERARD LIGHTING GROUP
The product includes a FIVE-YEAR WARRANTY against manufacturing defects. Full warranty terms can be found here at www.diginet.net.au COPYRIGHT. This document is copyright to Diginet Control Systems Pty Ltd. Except as permitted under relevant law, no part of this user and installation guide may be reproduced by any process without written permission of and acknowledgment to Diginet. DISCLAIMER. Diginet Control Systems Pty Ltd (Diginet) reserves the right to alter the specifications, designs or other features of any items and to discontinue any items at any time without notice and without liability. While every effort is made to ensure that all information in this user and installation guide is correct, no warranty of accuracy is given and Diginet shall not be liable for any error. TRADEMARKS. The identified trademarks and copyrights are the property of Diginet Control Systems Pty Ltd unless otherwise noted.
Approvals & Compliance
of 2 pages2
IP20
Specifications
Electrical
Dimmable
Via phase control dimmer input(Note: The minimum and maximum number of drivers which can be connected to a dimmer is dependent on the dimmer specifications)
Nominal Mains Supply Voltage 220-240Vac
Nominal Mains Supply Frequency 50/60Hz
Input Current 50mA @ 240Vac typical
Output Current 650mA dc constant current
Nominal Output Voltage 12Vdc – 16Vdc
Maximum Input Power 13W
Input PF ≥ 0.95 typical
Input THD < 15% typical
Rated Output Current 650mA (+/- 5%)
Line Voltage Regulation 100%
Nominal No-load Output Voltage 20Vdc
Short-Circuit Output Current 1.3A
Short-Circuit Load Protection Yes
Maximum Load Power Efficiency 77% typical
Turn-on Delay ≤ 500ms typical
Mechanical
Housing materialFlame Retardant Polycarbonate
Fixing 1 x 4mm diameter fixing hole
Mains connection cable1.2m long, pre-terminated with Australian/NZ 240VAC 10A mains plug
Mains Terminals Pre-terminated
Weight 180g
Dimensions See separate diagram
Environmental
Ambient Operating Temperature Range
0° to +50°C
Maximum Case Temperature
85°C (@ ta = 50°C)
Operating Humidity < 95% RH non condensing
IP Rating IP20
PRODUCT OF DIGINET CONTROL SYSTEMS PTY LTD
ABN 89 095 788 864 96-112 Gow Street Padstow NSW 2211 Australia
CONTACT INFORMATION
Internet: www.diginet.net.au General Enquiries: 1300 95 DALI (3254) sales@diginet.net.au Technical Services: 1300 95 3244 support@diginet.net.au Fax: 1300 95 3257
DESIGNTRUSTED AUSTRALIAN
™
650mA 13W LED DriverPhase Dimmable
Data Sheet DGLC650C13PD - Edition 01 Subject to change without notice. Latest updates available at www.diginet.net.au
Recommended