View
1
Download
0
Category
Preview:
Citation preview
Using: 6 – ½ inch x 2 inch bolts 12 – ½ inch flat washers 6 – ½ inch lock washers 1.- REMOVE THE TWO FACTORY SIDE NUTS AND BOLTS CLOSE TO THE FRAME, NEXT TO THE TOW HOOK. 2.- BOLT THE Z BRACKET FROM THE LONG END TO THE INNER FRAME BOLT HOLE. THE SHORT END OF THE Z BRACKET SHOULD LINE UP TO THE TOP OF THE TWO FRONT HOLES. 3.- ALIGN THE GRILLGUARD BRACKET TO THE TWO HOLES ON THE OUTER SIDE OF THE TOW HOOK. 4.- ATTACH GRILLGUARD WITH SAME FACTORY BOLTS PREVIOUSLY REMOVED. 5.- CHECK ALIGNMENT AND TIGHTEN BOLTS. PERIODICALLY RETIGHTEN BOLTS.
INSTALLATION INSTRUCTIONS
FOR PART NO. 1351P 2017 FORD SUPER
DUTY F-250/F-350 GRILLGUARD
Recommended