Post Tunnel Oven: Dump water from sheet pan into receptacle

1

Job Element Sheet Job Element Sheet

Process: Cheesecake Bake – Depanning ProcessAuthor: Andreana Crance, RIT MSDDate/Revision: 2/11/10, Rev 0

Post Tunnel Oven: 1. Dump water from sheet pan into receptacle 2. Place sheet pan on tray, filling both sides

3. Wheel full tray to depanning queueIf Large Cheesecakes: A. Wheel tray into cooler for 15-20 m. Ensure they are used in a First In First Out order

Cooler for Large Cakes

Depanning queue

2

Job Element Sheet Job Element Sheet

Process: Cheesecake Bake – Depanning ProcessAuthor: Andreana Crance, RIT MSDDate/Revision: 2/11/10, Rev 0Depanning Process:

4. Set up depanning area as shown in picture below- Bread Baskets- Insert Sheets- Foam Carriers

5. Wheel full tray to depanning area (arms length reach for Operator 1)

Wheel empty tray to depanning area (arms length reach for Operator 2)

Foam carriersBread Baskets Insert Sheets

Empty trayFull tray

3

Job Element Sheet Job Element Sheet

Process: Cheesecake Bake – Depanning ProcessAuthor: Andreana Crance, RIT MSDDate/Revision: 2/11/10, Rev 0

6. Grab tray from rack, set on cart work surface as shown in picture below

7. Dump cake from pan onto foam holder

4

Job Element Sheet Job Element Sheet

Process: Cheesecake Bake – Depanning ProcessAuthor: Andreana Crance, RIT MSDDate/Revision: 2/11/10, Rev 0

8. Flip cake onto permanent foam holder9. Place cake in bread basket 10. Remove empty sheet pan from table, set another

pan on table

5

Job Element Sheet Job Element Sheet

Process: Cheesecake Bake – Depanning ProcessAuthor: Andreana Crance, RIT MSDDate/Revision: 2/11/10, Rev 0

11. When necessary; change bread basket• Place sheet cover on top of cheesecakes for

protection