View
47
Download
3
Category
Tags:
Preview:
DESCRIPTION
Senior Thesis Presentation: The Westlake Recreation Center. Summer Padgett Faculty Advisor: Dr. Mistrick Westlake Recreation Center Westlake, Ohio Electrical / Lighting Option April 13 th , 2004. Building Information. Building Information: - PowerPoint PPT Presentation
Citation preview
Senior Thesis Presentation: The Westlake Recreation Center
Summer PadgettFaculty Advisor: Dr. MistrickWestlake Recreation CenterWestlake, OhioElectrical / Lighting OptionApril 13th, 2004
Building Information
Building Information:
• This facility serves as a park and recreation center for the citizens of Westlake.
• Total Building Area: 82,710 ft2
• Total cost of the construction: $15.3 million dollars
• Features four swimming pools, a gymnasium, locker rooms, a fitness room, a multi-purpose room, a babysitting room, a community room and recreation department offices.
Discussion TopicsLIGHTING Redesign of the lighting and controls systems
for 3 indoor spaces ELECTRICAL Addition of a generator so that the gym may
be used as an emergency shelter and the corresponding load redistribution and emergency panel addition
CM Cost analysis of a power factor correctionHVAC Mechanical analysis of adding a more efficient
glazing to the windows in one of my spaces
LIGHTING – Lobby
Total Ceiling Height: 27’-0”
SURFACES Reflective Wood Ceiling:
0.6 Burnt Sienna Quarry Floor
Tiles: 0.23
Alkyd Eggshell Walls: 0.5 Windows: 0.73
LIGHTING – Lobby
Main Main EntranceEntrance
LOBBLOBBYY
LOUNGLOUNGE AREAE AREA
Stairs to Stairs to MezzanineMezzanine
ReceptiReception Areaon Area
SNACK SNACK AREAAREA
LIGHTING – Lobby
Design Issues: Daylight
Design Ideas: Since the ceiling is so high, I wanted to
choose lighting that would bring it down some to make the lobby more inviting
Warm up the reception area so people will be drawn towards it
Carry in the fixture theme from outside
LIGHTING – Lobby
Equipment Selection:Reception Area: 2’x2’ Fluorescent Troffers over the desks Fluorescent Wallwashers on back wall Mini-Pendants lining the exterior of the desk CFL Downlights where the ceiling is lower in
frontLobby: Arm-mounted sconces Metal Halide Pendants Downlights in the sitting area up the stairs Sconces lining the brick wall going up the stairs
LIGHTING – Lobby
Renderings and Light Levels:
* THIS SLIDE STILL NEEDS WORK – LIGHT CALCS NOT YET COMPLETE - MAY NEED TWO SLIDES TO SHOW RENDERINGS – DAYLIGHT RENDERINGS MAY ALSO BE SHOWN HERE
LIGHTING – Lobby
Renderings and Light Levels:
* UNDER CONSTRUCTION!!
LIGHTING – Lobby
Renderings and Light Levels:
* UNDER CONSTRUCTION!!
LIGHTING – Community Room
Total Ceiling Height: 13’-3”
SURFACES Ceiling: 0.78 Carpet Floor:
0.15 Alkyd Eggshell
Walls: 0.5 Windows:
0.73
LIGHTING – Community Room
Main Main EntrancesEntrances
4 4 covescoves
Round Round tables tables throughothroughout the ut the roomroom
Moveable Moveable partitionpartition
WindoWindowsws
WindoWindowsws
WindoWindowsws
Design Issues: Daylight
Design Ideas: Make the room less formal looking,
more business-like Flush Ceiling
LIGHTING – Community Room
Equipment Selection:Option 1: Less Formal Indirect/Direct Pendants
hanging from coves CFL Downlights throughout the room Wall SconcesOption 2: Fluorescent strips in coves Small low-voltage MR16 downlights in coves Wall Sconces
* All bulbs 3000K
LIGHTING – Community Room
Renderings and Light Levels:
LIGHTING – Community Room
* THIS SLIDE STILL NEEDS WORK – LIGHT CALCS NOT YET COMPLETE - MAY NEED TWO SLIDES TO SHOW RENDERINGS
Renderings and Light Levels:
LIGHTING – Community Room
* UNDER CONSTRUCTION!!
Renderings and Light Levels:
LIGHTING – Community Room
* UNDER CONSTRUCTION!!
LIGHTING – Multi-Purpose Room
Total Ceiling Height: 13’-0” around perimeter then slopes to 24’-0”
SURFACES Wood Ceiling:
0.2 Northern Hard
Maple Floor: 0.75
Alkyd Eggshell Walls:
0.5 Windows: 0.73
LIGHTING – Multi-Purpose Room
Ballet Ballet barsbars
with full-with full-
lengthlength
mirrorsmirrors
on 3 of on 3 of thethe
wallswalls
EntrancEntrance from e from interiorinterior
Entrance Entrance from from exteriorexterior
Sloped, Sloped, wood wood ceilingceiling
SkylighSkylight in t in centercenter
Design Issues: Daylight
Design Ideas: Incorporate lighting that will not
create a lot of glare on the highly reflective floor
Make the dance studio more inviting by adding some pendants
LIGHTING – Multi-Purpose Room
Equipment Selection: Direct/Indirect pendants to hang from
the start of the skylight CFL Downlights around the perimeter
the room Wall Sconces Fluorescent strips in the coves
* All bulbs 3000K
LIGHTING – Multi-Purpose Room
LIGHTING – Multi-Purpose Room
Renderings and Light Levels:
* THIS SLIDE STILL NEEDS WORK – LIGHT CALCS NOT YET COMPLETE - MAY NEED TWO SLIDES TO SHOW RENDERINGS
LIGHTING – Multi-Purpose Room
Renderings and Light Levels:
* UNDER CONSTRUCTION!!
LIGHTING – Multi-Purpose Room
Renderings and Light Levels:
* UNDER CONSTRUCTION!!
LOAD REDISTRIBUTION PROCESS:
1) Determined Essential Loads: Gym lighting, receptacles Locker room lighting, receptacles Kitchen Lighting, Receptacles, and Equipment –
Refrigerator, ovens, microwaves HVAC equipment that services these areas
2) Sized a generator and emergency transfer switch based on the calculated loads (taking all demand factors into account)
3) Selected an emergency panel
4) Located generator 25’ from side of building (NEC code)
ELECTRICAL – GENERATOR ADDITION
• The selected equipment will appear here with an explanation of why it was chosen
• A map of the gym in relation to the exits,
locker rooms and kitchen will also be shown
here
ELECTRICAL – GENERATOR ADDITION
*Analyzed the financial impact of a power factor correction
based off of 12 months worth of utility bills
PROCESS1) PF = cos [tan-1(rKVA Demand/Measured KVA
load)]2) Calculated the PF for all 12 months Medium
General Service Schedule: REACTIVE DEMAND CHARGE = $0.48 per rKVA
3) Reactive billing demand = KW*(kVAR Hours/ kW Hours) – 30
5) Actual cost per month = Reactive billing demand*($0.48 / hour)
CM – PF CORRECTION
PROCESS (continued):
6) With the existing and desired power factors use the capacitor correction table to find a multiplier
7) Multiply the building’s electrical load by this number to get the KVAR of capacitors required
RESULTS:Total KVAR cost for 2002: $1691.15100 KVAR of capacitors needed to correct PFCost of 100 KVAR capacitor = $828 (Sprague
Corp.)Total savings for one year = $863.15*Almost an immediate payback!!
CM – PF CORRECTION
Here I plan to show the results of a mechanical
energy analysis when a more efficient glazing is
used on the windows in the lobby
CURRENT GLAZING PROPERTIES:1. Shading Coefficient: 0.812. Visible Light Transmittance: 73 percent3. Visible Light Reflectance: 17 percent4. Summer Value: 0.385. Winter U Value: 0.35
HVAC – MECHANICAL BREADTH
Here I will show the new glazing properties and
heat load calculations
HVAC – MECHANICAL BREADTH
• Van Dijk, Westlake, Reed, Leskosky – Cleveland, OH
• Faculty Advisor Dr. Richard Mistrick• Dr. Martin Moeck• Professor Ken Davidson – PSU Facilities
Engineering• Michael Rump – Westlake Recreation
Department• Bob Kelly – Engineer for the City of Westlake• John Durkee – Bacik, Karpinski, & Associates• Rajeev Chokshi – VWRL Architects and
Engineers• Phil LiBassi, Principal – VWRL Architects and
Engineers
SPECIAL THANKS
QUESTIONS / COMMENTS?
Recommended