SLS - Selective Laser Sintering Rapid Prototyping Carnegie Mellon Andy Sadhwani

SLS - Selective Laser Sintering

Rapid Prototyping

Carnegie Mellon

Andy Sadhwani

Selective Laser Sintering (SLS)

Manufacturing Technique Made with Plastic/Elastomer Powder Sample built layer by layer Horizontal Slide with Fixed Vertical Movement Powder stays on table Filetype ‘.stl’ used - structural triangle language Finished sample cools for 12-24 hrs then pulled

out of Powder

SLS Machine

SLS Powder

SLS con’t

Powder– Nylon-11

For High Strength and Elasticity

– Nylon-11 with 50% Glass Reinforcement– Nylon-12

Finer Surface Quality but lower elasticity

– Elastomer Simulate Rubber-Like Products

– Strain and Tolerances Available on Website

SLS con’t

No Limitation to Maximum Size– Sintered Parts can be Glued Together Easily

Providing High Strength– Single Part can be 30cm x 30cm x 60cm

Minimum Wall Thickness 0.85 [mm] for PA11

1.00 [mm] for PA11-GF50

0.65 [mm] for PA12

0.60 [mm] for Elastomer

Example of SLS Part (Drill)

Contact Information

Mareco bv Rijnaakkade www.marco.nl

Quotes Available through Email– Price Dependent on:

Height, Finishing, File Type

– Quote Available in One Day– 1 Week to Manufacture Part