View
5
Download
0
Category
Preview:
Citation preview
Surface preparation is key. De-grease surface prior to sanding with both a water borne and solvent degreaser.
Action: Remove paint from repair area and feather out edges. Use: P80 or P120 disc.
Action: Pre-clean repair area and apply relevant filler.
Action: Apply Dry Guide Coat.Use: Use either Mirka black/white powder guide coat, depending on filler colour.
Action: Block sand filler area.Use: Abranet® P80 or P120 or P180 strip, dependant on repair size.
Action: If required, apply additional filler to imperfections in repair.
Action: Re-apply Mirka Dry Guide Coat and block sand.Use: Abranet® P120 or P180 strip.
Action: Clean and Inspect repair and move to stage 2.
w w w . m i r k a . c o . u k
Stage 1: Panel Repair
1 2 3 4
5 6 7 8
Always use the correct PPE when undertaking any sanding operation, please refer to the TDS for all information. Always use dust extraction when undertaking any sanding operation.
Recommended