Stan meyeræs interfacing parts rebuild guide

Stan Meyer’s Interfacing Parts rebuild guide

To show how all parts go together

Sections● Design Drawings● Sources of Parts or pcs ready made● Part Specs● How to build methods or techniques● Measuring of finished part prior to install● Tools required for this part.● Buying complete ready made parts.● Q&A

All 8 elements of the cable connection bay can be seen :1) Alarm (7 pins)2) Dist (7 pins)3) Gate (2 pins)4) Accel (32 pins)5) Exhaust Gate (2 pins)6) TOR (8 pins)7) DC Power (2 pins)8 ) VIC Circuit (6 pins)

The GMS Unit connected to the Voltage Intensifier Unit.shown here

This rack contains 11 module cards and a cable connection bay with 12VDC rail terminals, 2 cable connection ports and a power switch.The card modules are (from left to right):1) Steam Resonator = this one is a important one makes steam and heats water to smooth out operations2) Resonant Cavity 10 = makes hydrogen3) Resonant Cavity 9= makes hydrogen4) Resonant Cavity 8= makes hydrogen5) Resonant Cavity 7= makes hydrogen6) Resonant Cavity 6= makes hydrogen7) Resonant Cavity 5= makes hydrogen8 ) Resonant Cavity 4= makes hydrogen9) Resonant Cavity 3= makes hydrogen10) Resonant Cavity 2= makes hydrogen11) Gas Processor ionises the air and excite the hyudrogen and oxygen Each of these cards have identical user interfaces.

This unit was mounted on the back of the water powered dune buggy as shown below.I thought it was interesting to note if they had one a voltage intensifer unit as 1 model for all these cells or many one for each cell?

This can be controlled with multi stage ecu controllers.

this bank is now off available off the shelf in ecu multi stage controllers.