View
216
Download
0
Category
Tags:
Preview:
Citation preview
SWPPPStormwater Pollution Prevention Plan
Self Inspection Training Program
2010
LaPorte County MS4 Co-op Program
Table of Contents Purpose of SWPPP training What is pollution? What is erosion? What is sediment? Benefits of prevention measures Required posting at jobsites Construction Sequencing Reporting and documentation Maintenance during construction Key points Pictures Fines $$$$$
Purpose of SWPPP Training
IT’S THE LAW !!!!!!!!!!!!!!!!!!!!!!!!!!!!!! Enforced by the Federal EPA via Clean Water Act of 1988,
National Pollution Discharge Elimination System (NPDES) 1990 Enforced by state and local administrations having jurisdiction
The Stormwater Pollution Prevention Plan (SWPPP) is designed to eliminate pollution from leaving the construction site.
To eliminate pollution of the U.S. waterways To ensure that all individuals understand the importance
of Best Management Practices (BMPs) on construction sites.
“Trained Individual”Must be familiar with SWPPP and have access to itMust understand the purpose of BMPsMust have authority to make correctionsMust be present at pre-construction meetingShould not be the excavating contractorShould be available onsite throughout the projectMust know what BMPs are included in the SWPPP, the
sequence of installation, proper maintenance of each, and be able to evaluate their effectiveness
Must be able to identify BMPs that are failing
What is Pollution? “The action of polluting especially by environmental contamination
with man-made waste” “The act of contaminating or polluting; including (either intentionally
or accidentally) unwanted substances or factors” “undesirable state of natural environment being contaminated with
harmful substances as a consequence of human activities”
Construction Site Pollution Waste or debris is generated by every person doing work on a
construction site. If the waste or debris is not contained and disposed of properly, it
becomes pollution. Good Housekeeping practices will reduce the potential for pollution.
What is Erosion? Erosion: Is the process in which, by the action of wind
or water, soil particles are displaced or transported
What are the types of erosion? Splash: Raindrop impact, dispersal and mobilization of soil particles Sheet: Saturated soils, soil particles entrained in run-off water, uniform
removal Rill: Increase topographic relief, higher run-off velocities, soil incision Gully: Concentrated flow, head cutting, down cutting Stream Bank: Natural drainage patterns, toe cutting, bank sloughing
What is Sediment? Sediment: eroded material suspended in water or in
the air. Sediment is the #1 pollutant of waterways. Sedimentation: the deposit of eroded materials When erosion occurs, small particles become
suspended in water or air and sediment is transported down-stream or down wind.
The purpose of stormwater pollution prevention is to minimize the opportunity for EROSION to occur, thus minimizing the possibility of SEDIMENT leaving the jobsite
Most concentrated sedimentation comes from construction, which can exceed 100 times that from agriculture.
What can be done to control sedimentation?
These simple devices can be used during construction to greatly reduce erosion and
minimize sedimentation.
Temporary and permanent stabilization Sediment fence or proper border Stone construction entrance Grass covered drainage ditches
Benefits of Prevention Measures? Reduce rainfall impacts Reduce surface water velocities Assist with stormwater infiltration Reduce and control sediment Eliminate off-site pollution
Protection of Soils Protection of soils can be established with vegetation.
However, other types of cover materials such as mulches, erosion matting, erosion blankets, must be used until vegetation is established to minimize splash and sheet flow erosion.
Effectiveness of soil protection is dependant on both the type and density of the specific cover material being utilized.
Overriding GoalProtect the quality of U.S. waterways by reducing the discharge of sediment, oil and chemicals into storm drains, surface water and
groundwater.
Required Job Postings
NPDES Permit Notice of Intent (NOI) Description of the project General Contractor’s local contact name and number Location of SWPPP Any other special conditions or required permits
All contained in a waterproof display case at construction entrance:
Additional Postings: Stormwater Pollution Prevention Sign Field Office sign posted on trailer Spill Containment System location
Inside the Job Trailer: Original SWPPP Working SWPPP drawing
Construction Sequencing
Phase I installation of the following: Construction entrance (s) Silt fence or other barrier BMP …BEFORE any major grading Check dams Diversion drains Inlet protection Swales Detention pond, sediment basins and traps Concrete washout area per SWPPP Vehicle maintenance / fueling area Stoned storage / laydown area
Phase II Additional phased BMPs per SWPPP Temporary stabilization (any area which will not be worked for 15
days or more) Permanent stabilization
Contact IDEM and Local Authority 48 hours prior to beginning grading activities.
Reporting and Documentation
Reporting Reporting submitted to Owner and PM Weekly inspection summary Rainfall (1/2”) Event inspection summary EPA, State, or Local jurisdiction inspections Spill report form
Documentation Site stabilization Contractor and subcontractor certifications Notice of Termination (NOT) E&S Plan
All SWPPP records must be maintained a minimum of three years after Notice of Termination.
Maintenance During Construction
New or major grading will be recorded in SWPPP binder-Site Stabilization
Repairs, discharges, modifications and alterations should be recorded daily on the Working SWPPP
Inspection reports document repairs, discharges, effectiveness, and should be recorded in the SWPPP binder
Photographic documentation should be taken of the site conditions and used to document the effectiveness of, alterations to, and repairs to any BMPs
Transition from temporary to permanent stabilization is critical
Reporting the failure of a BMP is the responsibility of all employees on the jobsite…this means YOU!!!
Additional Measures Needed
If BMPs are failing, the designer must be notified. It is the designers responsibility to find corrective BMPs
Owner should also be notified of problems Problems must be clearly identified, including
exact location and observations Suggestions should be recorded. Often, the
person on site can be instrumental to helping the designer find solutions
Key Points
IT IS THE LAW !!!!!!!!!!!!!!!!!! Construction Sites are active, and SWPPP will change
every day. Documentation is required. It is the responsibility of every person on the jobsite to
report any changes that are made, or need to be made, to the erosion and sediment controls
All erosion and sediment controls are inspected weekly and after every ½” of rain, or thaw
Any discharge of sediment from the jobsite must be reported immediately!
Vehicle track-out (mud from tires) is pollution !! Employees should know the location of the SWPPP
Jobsite Pollution
Waste and debris that is not properly controlled and disposed of is pollution!
Jobsite Pollution
Waste and debris that is not properly controlled and disposed of is pollution!
Jobsite Pollution
Fuel and oil based products that are not contained or properly disposed of are pollution!
Spill Containment
The spill containment kit shall be used if at any time oil or fuel based products are spilled or leak from their container.
Pollution such as this must be reported to the Bureau of Water Quality and contained immediately!!!
Proper storage of hazardous materials will eliminate the opportunity for pollution.
Secondary containment is a valuable tool for preventing spills in the first place.
Jobsite Pollution
Display Case and Signage
SWPPP Site Plan
The SWPPP is a living document that is updated on a daily basis. The SWPPP should be located at the Field Office.
Silt Fence Examples (BAD!)
Silt Fence Examples (Good!)
Silt Fence Maintenance
Must be trenched Must be installed facing the proper direction Must have properly wrapped connections Remove sedimentation when it reaches 1/3 the height of
the fence Must be repaired as needed
Inlet Protection (Bad)
Frames inadequate Not trenched Not reinforced Not maintained
Frames properly built Properly trenched Reinforced filter fabric Anchored Should allow for overflow
in case of heavy rainfall
Inlet Protection (Good)
Seeding and Stabilization (Bad)
Lack of stabilization has allowed washout of soils Areas have remained idle for more than 15 days Mulch or matting could have prevented most of this erosion
Seeding and Stabilization (Good)
Areas have received final grade while other areas are still under construction
Pond and channel slopes have received blanket to combat erosion Sod installed in concentrated flow areas
Concrete Wash Out (Bad)
Concrete wash out is pollution! Concrete washouts should be provided for delivery trucks.
Concrete Wash Out (Good)
Pit lined with continuous 10 mil liner Stormwater run off protected from contamination
Construction Entrance
Bad
Good
Citizens can initiate civil suits against:
An individual person A construction company The U.S. or any other government entity The EPA itself
Compliance Avoid costly Stop Work Orders
In many jurisdictions, violations causing an immediate danger to the environment do not require prior notice for Stop Work Orders to be
issued.
Compliance
And even more costly fines of up to $25,000 per day from IDEM
EPA Administrative Fines
Currently $260 Million fines against builders in litigation
EPA Non-Compliance Violations include
• No permit• No SWPPP• No inspection records• No amendments to SWPPP
Rick BrownLaPorte County MS4 Co-op ProgramMS4 Coordinator-Stormwater Management
2857 W St. Rd #2, Suite BLaPorte, IN 46350(219) 608-8243 Cell(219) 326-6808, Ext. 2114 Office(219) 369-0599 FaxEmail rbrown@laportecounty.org
Recommended