Materials you will need

1. Old or new mailing tubes/cylindersWe made three ‘vases’ from one tube, approx. 9cm diameter2. Wallpaper samples to fit preferred length of vase3. Hacksaw4. Ruler5. Scissors6. Craft glue or indoor PVC glue (e.g Aquadhere)7. Brush8. Metallic tape (we used copper

50 mm & aluminium 18mm)

Measure and cut cardboard tube

Mark along the length of the mailing tube your preferred length/height for each vase. We created three – 8cm, 21cm, 35cm.

Only two will have the plastic inserts to use as a base for the vase. Using the hacksaw, score all the way around making a shallow channel, this helps keep your cut straight as you saw through the cardboard. Turn the tube as you cut.

 Measure and cut wallpaper

Measure and cut the wallpaper pieces to fit each individual tube. Allow at least 2cm extra along the longest side as overlap when wrapping around the tube. Add an extra 5 – 7cm extra in length for pasting the paper on the inside of the vase.

Brush on glue

Take the first tube with a plastic base insert. Brush the glue to the entire tube surface. Gaps will cause a bubble, so check glue coverage is even.

Attach wallpaper

Position wallpaper over glue aligning it with the bottom of the tube. Smooth down the paper right around the surface to avoid air pockets.

Cut slits in paper ends

At the other end of the tube there will be the 5-7cm of wallpaper overhang. Make 8 cuts at regular intervals from the edge of the paper to rim of the tube. Coat the inside top of the tube with glue and fold down the paper flaps inside.

Adhere metallic trim

Repeat the same steps with the other tube and other paper. The vase can be left plain, or can add a metallic trim. For the trim, measure the circumference with a tape measure (3.14 x 9.5 cm diameter, approx. 30cm). Cut metallic tape to circumference measurement plus 2.5cm. Crumple really well in your fist, uncurl and flatten out. Peel off backing and stick to the outer edge of tube, allow 8mm showing on the outer rim, the remainder is smoothed over the edge and adhered to the inside of the tube.

Finished metallic trim

Metallic trim can be used at base, if using tube without plastic insert.

Tube with plastic base

To use as a vase, place a jar with water on the table, place the hollow tube over the top. Or if using a tube with a plastic base, place the jar inside the tube, then add water and fill with branches, or display flowers.

Display your flowers

Here we’ve used tufts of orange tissue paper on a branch for effect. The smaller squat vase could be used as a candle holder.