8/7/2019 04 09 RANGE ROVER SPORT FENDER VENTS INSTALLATION
MANUAL CARID.COM
1/3
8/7/2019 04 09 RANGE ROVER SPORT FENDER VENTS INSTALLATION
MANUAL CARID.COM
2/3
2 Copyright 2008 by E&G Classics, Inc.
7. Align the fender vent and using an pen or pencil, markthe
four (4) mounting hole locations onto the maskingtape.
8
9
11. E&G recommends the use of a high quality sealer on
allholes drilled through the front fenders to prevent futurerust
problems.12. Install the CNC fender vents using the supplied #6
x
1/2 countersunk phillips screws. DO NOT OVERTIGHT-EN or you
could strip out the mounting holes.
12
8. Carefully remove the fender vent and use a 3/32 drill bitto
drill through the centers of tha marks made in theprevious
step.
9. On the driver side fender vent, apply flat or semi-glossblack
paint to the inside of the opening that would bevisible through the
openings in the fender vent.10. Once you are finished painting,
remove the maskingtape around the fender vent openings.
8
11
7
13. Carefully peel back a small section from each of
thestainless steel fillers prior to removing the backing fromthe
preinstalled double faced tape.14. Align the fillers into their
respective recesses, pressingfirmly enough to set the tape.
1411 12
8/7/2019 04 09 RANGE ROVER SPORT FENDER VENTS INSTALLATION
MANUAL CARID.COM
