Upload
hoangdat
View
213
Download
0
Embed Size (px)
Citation preview
If you have a flat tire while driving,stop in a safe place to change it.Drive slowly along the shoulder untilyou get to an exit or an area that isfar away from the traffic lanes.
The jack is behind a cover in thecargo area on the driver’s side,and tools are on the back of thecover. Remove the cover bypushing the tabs down and pullingthe cover out.
Turn the jack’s endcounterclockwise to loosen it, thenremove the jack.
Park the vehicle on firm, level, andnon-slippery ground. Put thetransmission in Park. Apply theparking brake.If you are towing a trailer, unhitchthe trailer.
Turn on the hazard warning lights,and turn the ignition switch to theLOCK (0) position. Have allpassengers get out of the vehiclewhile you change the tire.
2.
1. 3.
4.
Changing a Flat Tire
366
JACK
SPARE TIRE
TOOLS
The vehicle can easily roll offthe jack, seriously injuringanyone underneath.
Follow the directions forchanging a tire exactly, andnever get under the vehiclewhen it is supported only by thejack.
05/07/07 14:08:53 31SHJ610 0369
The spare tire is stored behind acover on the sidewall of the cargoarea on the driver’s side.
Remove the cover by holding thetwo handles and pulling the coverout.
Unscrew the wing bolt, and takethe spare tire out of its holder.
If you are changing a rear tire,close the sliding door. Then turnoff the sliding door MAIN switch.
Loosen each wheel nut 1/2 turnwith the wheel nut wrench.
Place the jack under the jackingpoint nearest the tire you need tochange. Turn the end bracketclockwise until the top of the jackcontacts the jacking point. Makesure the jacking point tab isresting in the jack notch.
5.
6.
7.
8.
9.
CONTINUED
On EX and EX-L models
Changing a Flat Tire
Taking
Care
ofthe
Unexpected
367
WHEEL NUTS
05/07/07 14:09:02 31SHJ610 0370
Use the extension and the wheelnut wrench as shown to raise thevehicle until the flat tire is off theground.
Remove the wheel nuts, thenremove the flat tire. Handle thewheel nuts carefully; they may behot from driving. Place the flat tireon the ground with the outsidesurface facing up.
Do not attempt to forcibly pry thewheel cover off with a screwdriver orother tool. The wheel cover cannotbe removed without first removingthe wheel nuts.
Before mounting the spare tire,wipe any dirt off the mountingsurface of the wheel and hub witha clean cloth. Wipe the hubcarefully; it may be hot fromdriving.11.
10. 12.On LX model
Changing a Flat Tire
368
WHEELWRENCH
EXTENSION WHEEL COVER
HUB
05/07/07 14:09:08 31SHJ610 0371