Embed Size (px)
Citation preview
1. Unscrew the crankcase.
2. Unscrew the controlbox cover. 3. Connect the connectors as below - The long yellow connector from the controller goes to the assistsensor.- The short yellow connector from the controller goes to the rearlight.- The Short red connector from the controller goes to the frontlight.The long red connector goes to the kickstand.- Connector from the - The cable from the motor has a line after the arrow on the connector. that line the female contact must meet.- The battery connector should be inserted all the way so that the female connector meets the arrow.
4. Screw the cover to the control box. 5. Install pedal sensor.
6. Connect the plug. 7. Screw the pedal arm back on. Be sure to screw it on as tightly as possible.
-Important! Make sure that the pedal arms are in different directions as the picture above.
8. Fit the steering. 9. Place the display and keystroke on the handlebars.
10. Connect the display connector. 11. Place the spacers at the display bracket.
12. Screw in the screws to the display. 13. Screw in the screw for the keypad.
14. Pull up the cable gland and secure all cables with the supplied cable ties.
On your keypad, hold down "set" for five seconds to access the menu.Scroll down to "Assistance Inactive" andpress the ”set” button on the trip computer tomake it selectable. Change from YES to NO with up or down arrow. Press the start button again to save it. Go down to Save & Exit using the arrows and press the start button to exit the menu.
activate pedalassist
troubleshooting
Everything is mounted but my RAWBIKE is not assisted?
Answer: Check that you have an assist level set between 1 and 5.
Answer: Check that you have saved the settings in your trip computer, that the selection is "NO" on assist inactive.
Answer: Loosen the connection to the sensor and see that no contacts are bent or wrong. Then try to fix and reassemble.
If you still do not get your RAWBIKE started, contact us at [email protected] and we will help you get started.
Everything is assembled but you get an errormassage?
Hall error: Check that the motor cable is in all the way, the line after the arrow on the male connector should meet
female contact.
Engine diactivated: This is not an error message but an indication that the kickstand is folded down.
The message does not disappear when you fold up the kickstand? Check that the plug at the kickstand is mounted correctly.
Display recieving error: Do you get this message?Contact us at [email protected]
rawbike [email protected]
08-221224
