Registering the SPA922 Document ID: 109116 Contents Introduction How do I register the SPA922? Related Information Introduction This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products (formerly Linksys Business Series). Refer to Cisco Technical Tips Conventions for more information on document conventions. Q. How do I register the SPA922? A. Follow the instructions provided below: Access the web based setup page of the SPA922. Verify the IP address through the LCD. Click Menu then press 9. It should show you the DHCP IP address. Open a browser and type that in the Address bar. 1. Click Admin Login and then advanced. Note: The SPA922 does not have a username and password by default. If you are asked for a username and password and you have not configured a password, it means that the SPA921 is locked by your VoIP provider. You need to obtain the password from your VoIP provider. 2. Click the EXT 1 tab. Under Proxy and Registration >> Proxy, enter the proxy server. This should be given to you by your VoIP provider. There are times when VoIP providers requires an Outbound proxy, verify the server address with them. Under Subscriber Information, enter the User ID and Password. 3.
IntroductionThis article is one in a series to assist in the
setup, troubleshooting, and maintenance of Cisco Small
Businessproducts (formerly Linksys Business Series).
Refer to Cisco Technical Tips Conventions for more information
on document conventions.
Q. How do I register the SPA922?A. Follow the instructions
provided below:
Access the web based setup page of the SPA922. Verify the IP
address through theLCD. Click Menu then press 9. It should show you
the DHCP IP address. Open abrowser and type that in the Address
bar.
1.
Click Admin Login and then advanced.
Note: The SPA922 does not have a username and password by
default. If you areasked for a username and password and you have
not configured a password, itmeans that the SPA921 is locked by
your VoIP provider. You need to obtain thepassword from your VoIP
provider.
2.
Click the EXT 1 tab. Under Proxy and Registration >>
Proxy, enter the proxy server.This should be given to you by your
VoIP provider. There are times when VoIPproviders requires an
Outbound proxy, verify the server address with them.
UnderSubscriber Information, enter the User ID and Password.
3.
Click Submit All Changes.4. Check the Status in the Info tab.
Ext 1 should say Registered under RegistrationState.
5.
Related InformationTechnical Support & Documentation Cisco
Systems
Contacts & Feedback | Help | Site Map 2013 2014 Cisco
Systems, Inc. All rights reserved. Terms & Conditions | Privacy
Statement | Cookie Policy | Trademarks ofCisco Systems, Inc.
