Current sensor for external neutral conductor for 140G-N, 140G-NS, 140G-RSensore di corrente per conduttore neutro esternoStromsensor für außenliegenden NeutralleiterCapteur de courant pour conducteur neutre extérieurSensor de corriente para conductor neutro externo

Bul. 140G

DIR 1000529R0513 (L6151)

WARNING:

WARNUNG:

AVERTISSEMENT:

To prevent electrical shock, disconnect from power source before installing or servicing. Install in suitable enclosure. Keep free from contaminants. (Follow NFPA70E requirements).

AVVERTENZA: Per prevenire infortuni, togliere tensione prima dell'installazione o manutenzione. Installare in custodia idonea. Tenere lontano da contaminanti. (Seguire i requisiti NFPA70E).

Vor Installations- oder Servicearbeiten Stromversorgung zur Vermeidung von elektrischen Unfällen trennen. Die Geräte müssen in einem passenden Gehäuse eingebaut und gegen Verschmutzung geschützt werden. (Befolgen Sie die Anforderungen nach NFPA70E).

Avant le montage et la mise en service, couper l'alimentation secteur pour éviter toute décharge. Prévoir une mise en coffret ou armoire appropriée. Protéger le produit contre les environnements agressifs. (Vous devez respecter la norme NFPA70E).

ADVERTENCIA: Desconéctese de la corriente eléctrica, antes de la instalación o del servicio, a fin de impedir sacudidas eléctricas. Instálelo en una caja apropiada. Manténgalo libre de contaminantes. (Cumpla con los requisitos NFPA70E).

ATENÇÃO: Para evitar choques, desconectar da corrente elétrica antes de fazer a instalação ou a manutenção. Instalar em caixa apropriada. Manter livre de contaminantes. (Cumpra as exigências da norma NFPA70E).

Installation - Installazione - Instalación Instalação - -

140G-N

140G-NS

140G-N-NCTE16, 140G-R-NCTE30

140G-R

ONLY FOR 140G-N, 140G-NS

21

2 1

2 1

1

DIR 1000529R0513 (L6151) (2)

2

35 (1.38")

35 (1.38") 1

5 (

0.6

")

3 140G-N140G-NS

26 (1.02")

83

.5 (

3.2

9")

53

.5 (

2.1

")

36 (1.41") 41 (1.61")

81 (3.19)

60 (2.36")

35 (1.38")

96 (3.78")

117 (4.6")

15

(0

.6")

20

0 (

7.8

7")

140G-N, 140G-NS 140G-R

T7

T8 K1

K2

T5

T6

W4

W3

95S

98SW2

W1

K14

K15

K12

K13

K11

K10 T2

T3

T1

T4

T6 T5

T6T5

4 140G-N, 140G-NS

DIR 1000529R0513 (L6151) (3)

>

ELECTRONIC TRIP UNIT

>>

>>

>>>

>>

LSlG

T6

T5

UI/N

NPE

TWISTED PAIR OFSHIELDED WIRES

48

5 140G-N, 140G-NS

6 140G-R

T5

T6

T8

T7 T6

T5 W4

W3 98S

95S W2

W1 K15

K14 K12

K13 K10

K11 K1

K2 T2

T3 T4

T1

U2

U1

38

37

96

95

E

98

T2 C3 CC2

T1 C13 CC1

T6

T5

T1

T2

T3

T4

C1

3

C3

CC

1

98 EU1

T1

T2

T3

T4

T5

T6

C1

3

C3

CC

1

U2

37

38

95

96

U1

U2

37

38

95

96

98 E

* *300 max.

* *300 max.

T4

T3

T6

T5

T6T5

DIR 1000529R0513 (L6151) (4)

Terminal stripMorsettieraKlemmensleisteBornierPlaca de bornes

Sliding contactsContatti strisciantiGleitkontakteFrotteursContactos deslizantes

7-The orientation of the sensor on the external neutral has to be the same as the orientation of the sensors installed on the CB.-L’orientamento del sensore sul neutro esterno deve essere uguale all’orientamento dei sensori installati sul CB.-Der Sensor auf dem externen Neutralleiter muss in derselben Weise wie die Sensoren auf dem Leistungsschalter ausgerichtet sein.-L'orientation du capteur sur le neutre extérieur doit être identique à celle des capteurs installés sur le disjoncteur.-La orientación del sensor en el neutro exterior debe ser igual a la orientación de los sensores instalados en el IA.

Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc.Trademarks not belonging to Rockwell Automation are property of their respective companies.

Copyright © 2013 Rockwell Automation, Inc. All Rights Reserved.

DIR 1000529R0513 (L6151)Publication 140G-IN117A-MU-P - April 2013

Upper terminalTerminale superioreOberer AnschlußPrise supérieureTerminal superior

Lower terminalTerminale inferioreUnterer AnschlußPrise inférieureTerminal inferior

CONFIDENTIAL AND PROPRIETARY INFORMATION. THIS DOCUMENT CONTAINS CONFIDENTIAL AND PROPRIETARY INFORMATION OF

ROCKWELL AUTOMATION, INC. AND MAY NOT BE USED, COPIED OR DISCLOSED TO OTHERS, EXCEPT WITH THE AUTHORIZED WRITTEN

PERMISSION OF ROCKWELL AUTOMATION, INC.

Sheet

Size Ver

Of 11

A 0010000028320Dr. DateG. USHAKOW 02-12-10

MATERIALSIZE

FOLD

TO BE DETERMINEDBY STRATEGIC PARTNER

TO BE DETERMINEDBY STRATEGIC PARTNER

TO BE DETERMINEDBY STRATEGIC PARTNER

FLAT

SPECIFICATIONS FORINSTRUCTION SHEET CREATED BY STRATEGIC PARTNER

This Instruction Sheet is Being Printed by Strategic Partner

Note: After folding---Printed in (Country where printed)* and instruction sheet number in lower left corner should be visible.

* The printing vendor may change the instruction sheet files to show the correct country.