Screw the 8 Hex Spacers to the case as shown above.

Insert 2 x Pi-Clips into the front of thecase, notice the position of the Pi-Clipsand also the orientation of the clips.

Insert your Raspberry Pi, and slide itinto the front Pi-Clips, Note the SD Slotof your Pi should be at the front of thecase.

Insert the 2 remaining Pi-Clips, theseare located next to Audio and USBsockets on your Pi.

Remove the protective film from thetop Wafer.

Place the wafer onto the 4 Pi-Clips.Notice the orientation of the waferon the image above.

Secure the Wafer using 4 Screws Repeat Steps 2-7 for your secondRaspberry Pi if required.

Package Contents

1 x uPi Rack2 x uPi Wafer16 x M3 x 12 Screws8 x M3 x 20 Hex Spacers8 x Plastic Pi-Clips

uPi Version 2 , Raspberry Pi Rack Mount, Instructions 02.2013

1u Rack Mount for 2 x Raspberry Pi

Raspberry Pi is a trademark of the Raspberry Pi Foundation

1 2 3 4

5 6 7 8