Page 1
Beth Katz
Pattern generated by Flexagon Creator at http://www.flatfeetpete.com/flexagon/Instructions adapted from that site ©2002, 2012 Peter Bradshaw
Beth Katz
1. Carefully cut out long central strip.
Beth Katz
2. Fold strip in half lengthwise to create a strip one triangle wide printed on both sides. CREASE ALL FOLDS.
Beth Katz
2014 STEM Camporee Hexahexaflexagon
Beth Katz
3. Note that the pictures around this page (i. to vii.) match your strip. Hold your strip so that it matches the long strip of picture i.
Beth Katz
4. Fold 2 triangles above dotted line away from you to make folded picture i.
Beth Katz
folded picture i
Beth Katz
5. Keep folding top two triangles away from you along dotted lines as shown in pictures ii and iii.
Beth Katz
6. Folded strip should look like picture iv. front and back. If not, unfold and try again.
Beth Katz
7. Starting with the lower strip of picture iv., fold the RIGHT side away from you on the dotted line to get picture v.
Beth Katz
8. Fold the top part of v. away from you to get picture vi.
Beth Katz
9. Underneath the one triangle that is not the BSA fleur-de-lis you will find the other end with Glue X. Lift it up and over the purple triangle.
Beth Katz
10. Glue the two Glue X tabs together.
Beth Katz
11. Flex to see six different sides. Some sides can go to two different sides, but some only go to one other side.
Beth Katz
Beth Katz
![[305] GLUE-DOWN: FULL-WIDTH STEP AND TACTILE STRIP · 1350 x 400 mm L009 0005 Yellow 0007 Light grey 0009 Dark grey 400 mm 3 FLOORS IN BUILDINGS [305] GLUE-DOWN: FULL-WIDTH STEP AND](https://img.pdfslide.net/doc/110x75/5fb45a820d8c3830cf7d7636/305-glue-down-full-width-step-and-tactile-strip-1350-x-400-mm-l009-0005-yellow.jpg)
