Upload
greenosonic-foundation
View
147
Download
0
Embed Size (px)
Citation preview
3
DETAILS This movable toilet is made of Sandwich Panel, C shaped Steel, details as follows. Co-efficient of thermal conductivity :- <0.041w Density: - 18 – 22 Kg/m3 Foam thickness: - 50 mm Steel Thickness: - 0.386 mm Each toilet is equipped with following:- Squat Toilet (Indian Sitting), Flush Tank, Wash Basin, Urinal, Exhaust fan, Light, Tap, Handle, Latch and Mirror. Standard size of toilet 4.264 Foot X 4.264 Foot X 7.6 Foot
Mrs. Lata Jha – [email protected]
- IT HAS LOW CO-EFFICIENT OF THERMAL CONDUCTIVITY AND - THERMAL EXPANSION.- ITS COMPRESSIVE STRENGTH :- > 0.1 MPA- ITS WATER ABSORPTION CAPACITY IS :- < 4% ~V/V~- LIGHT WEIGHT - HIGH STRENGTH TO WEIGHT RATIO- CORROSION RESISITANCE- WEATHER RESISITANCE- LOW MAINTENANCE- LONG TERM DURABILITY- TAILORED SURFACE FINISH- RADAR TRANSPARENCY- HIGH IMPACT STRENGTH- PART CONSOLIDATION- NON – MAGNETIC.
THESE ARE FEW ADVANTAGES OVER NORMAL CEMENT OR WOOD MADE TOILETS.
ADVANTAGES OVER OTHER TOILETS
Mrs
. Lat
a Jh
a –g
reen
oson
ic@
gmai
l.com
4
Mrs
. Lat
a Jh
a - g
reen
oson
ic@
gmai
l.c
om
Comparison between traditional toilet of bricks, cement and sand against movable, portable toilets.
Sr. No. Traditional toilets Portable toilets1 To make conventional toilets one has to non eco
friendly materials i.e. cement and bricks while construction, the environment gets polluted and also place where it is constructed gets dirty.
To keep portable toilets we use eco friendly materials, thus helping in keeping environment clean.
2 To make conventional toilets one has to block the surrounding area for the construction purpose, thus carrying delay in traffic and also causing inconvenience to the pedestrians.
For installation of this ready to use portable toilets, we take maximum 8 hours for toilets having 3 blocks of latrine and 2 shower areas. Thus it saves time, helps in neither disturbing traffic nor causes any inconvenience to pedestrians.
3 To make conventional toilets, say hardly four blocks of latrine and two shower areas, minimum time required will be 45 to 60 .
As they are fully equipped and ready to use, we neither depend on any raw material nor any labor.
4 After construction of the traditional toilets, one has to be careful of leakage in rains.
As this toilet is leak proof, there is no chance of leakage and hence no chance of short circuit.
5 If the road is widened, this toilet have to be dismantled, as they cannot be reused. The maintenance cost of this toilet is very high, as the tiles if broken, leads to leakage and damages floor etc.
If the roads need to be widened then this toilet can be shifted as it is, to the other location without any damage and can be reused.
6 Due to leakage problems, there are chances of short circuit and hence causing death hazards.
The maintenance cost is very low as the material used as floors are easily workable.
5
13Mrs. Lata Jha - [email protected]