Upload
trinhnga
View
221
Download
0
Embed Size (px)
Citation preview
+12v Constant = Red/Orange +12v Acc. Switch = None (CAN BUS) -12v Chassis Ground= None (CAN BUS) +12v Illumination = None +12v Dimmer = NoneAntenna/Amp Remote =None (CAN BUS)
LF+ = NoneLF- = None
RF+ = None RF- = None LR+ = Green/Blue LR- = Green/Purple RR+ = Grey/Blue RR- = Grey/Blue
Dash Type : Din and 1/2Aftermarket: Single/Double DinKit: CR1286B/CR1289BHarness: CR03SRAntenna Adapter: CRAB/CRARB
About the Vehicle
Make: JeepModel: CommanderYear: 2006-07
In Dash Application
Wire Color Codes
Speaker Notes
Front Speaker Sizes
Rear
NOTES
Dimensions: Lower Door
Dimensions: Lower Door W= 7.180'' L= 2.841'' D= 5.835''
NOTES
Rear Door: 6.5'' MidrangeSpeaker Adapter: SAC656Factory Assembly: (3) Phillips head screws securingspeaker.
Standard/Optional
Ampli�er Locations: Behind Left Rear Side Panel.
W= 6.169'' L= 8.778'' D= 3.143''
Type: Standard Audio System Location: At Speakers
Speaker Sizes
Front Dash: 3.5'' TweeterLower Door: 6X9 MidrangeSpeaker Adapter: SA69Speaker harness: TBAFactory Assembly: (4) Phillips Head screws securingspeaker.
CD PlayerBoston Acoustic Sound SystemIn-Dash CD Changer (6 Disc)Satellite RadioNavigation SystemRear Seat DVD System6 Speaker System
Jeep Commander2006-07
Images
Front Speaker
Radio removal
Front Speaker(s)
Rear Speaker(s)Rear Speaker
Radio
Tweeter
1. Remove (16) silver Allen head screws from front of dash.Carefully pull dash from right front corner to releaseretainer clips.Then continue releasing retainer clips alongtop of dash from right to left.There are two clips on dash above steering column that need to be released.There is (1)clip on dash right below radio. Once all clips releasedremove dash.2. Remove (2) Philips screws on each side of radio and pull out.
Dash Tweeter
Front Door
1. Remove screw under door closer handle. 2. Remove plastic screw cover behind door opener handle. Remove screw. Unsnap door panel. Lift panel up and pull out.3. Disconnect plugs from door panel. Disconnect door opener rod. Remove (3) screws holding speaker in.
1. Use small panel remover and pop grill off.There are (4) clips holding grill on.2. Remove (2) screws from speaker and remove
1. Remove screw from upper door panel closest to vehicle.2. Remove screw under door closer handle. Remove plasticscrew cover behind door opener handle. Remove screw.Unsnap door panel. Lift panel up and pull out.3. Disconnect plugs from door panel. Disconnect door openerrod.4. Remove (4) screws holding speaker in.
Rear Door
Jeep Commander2006-07