Upload
others
View
17
Download
0
Embed Size (px)
Citation preview
(800) 878-1369 www.consolevault.com
2019-2021 — Dodge Ram
Instruction Sheet (1093)
1. Installation Steps:
2. If applicable, reset the combination lock before beginning installation.
3. Remove all contents from the center console, except the OEM pad at the bottom.
4. Slide the Cup Holder all the way forward before starting the installation. (A1)
5. Make sure the Flap Divider is in the up and secured position before beginning the installation. (A2)
6. Insert the safe into the console by slightly tilting, allowing the sides to clear the side hang hooks in the console. (A3)
7. After clearing the hang hooks, tilt the front of the safe down and push it forward locking the front to the two corner
locking features. Then push down on the back of the safe to complete the positioning procedure. (A4)
8. Insert the 4 screws by hand, and proceed to tighten using a 7/16” socket wrench. When the screwhead touches
the insert nuts STOP, do not overtighten. NOTE: Overtightening the screws will cause damage to the threaded
inserts. (A5)
9. The installation is now complete! (A6)
A1 A2 A3
A5 A4 A6