Upload
others
View
15
Download
0
Embed Size (px)
Citation preview
#60295 TOOL ORGANIZERASSEMBLY INSTRUCTIONS
MM061212
It will take just a few minutes to prepare yourTool Organizer for use. Only a pencil is needed.
340 Snyder Avenue
Berkeley Heights, NJ 07922
Tech Support: 908-464-1094, 1pm–5pm ET
www.micromark.com [email protected]
D D D D D D D D
C C C C C C C
AB B B B A
2. Insert two large tubes (2-1/2” long) into holes marked A in
the photo below.
3. Insert four small tubes (2-1/2” long) into holes marked B.
4. Insert seven small tubes (4” long) into holes marked C.
5. Insert eight small tubes (5” long) into holes marked D.
Position the bottom of each tube between the guide rails
molded into the inside of the bottom cover: Insert the eraser
end of a pencil into the tube and use as a tool to shift the
bottom end into position.
1. Peel and stick one rubber foot to each of the circles molded
into each corner of the bottom cover.
#60295 TOOL ORGANIZERASSEMBLY INSTRUCTIONS
MM061212
It will take just a few minutes to prepare yourTool Organizer for use. Only a pencil is needed.
340 Snyder Avenue
Berkeley Heights, NJ 07922
Tech Support: 908-464-1094, 1pm–5pm ET
www.micromark.com [email protected]
D D D D D D D D
C C C C C C C
AB B B B A
2. Insert two large tubes (2-1/2” long) into holes marked A in
the photo below.
3. Insert four small tubes (2-1/2” long) into holes marked B.
4. Insert seven small tubes (4” long) into holes marked C.
5. Insert eight small tubes (5” long) into holes marked D.
Position the bottom of each tube between the guide rails
molded into the inside of the bottom cover: Insert the eraser
end of a pencil into the tube and use as a tool to shift the
bottom end into position.
1. Peel and stick one rubber foot to each of the circles molded
into each corner of the bottom cover.
#60295 TOOL ORGANIZERASSEMBLY INSTRUCTIONS
MM061212
It will take just a few minutes to prepare yourTool Organizer for use. Only a pencil is needed.
340 Snyder Avenue
Berkeley Heights, NJ 07922
Tech Support: 908-464-1094, 1pm–5pm ET
www.micromark.com [email protected]
D D D D D D D D
C C C C C C C
AB B B B A
2. Insert two large tubes (2-1/2” long) into holes marked A in
the photo below.
3. Insert four small tubes (2-1/2” long) into holes marked B.
4. Insert seven small tubes (4” long) into holes marked C.
5. Insert eight small tubes (5” long) into holes marked D.
Position the bottom of each tube between the guide rails
molded into the inside of the bottom cover: Insert the eraser
end of a pencil into the tube and use as a tool to shift the
bottom end into position.
1. Peel and stick one rubber foot to each of the circles molded
into each corner of the bottom cover.