ITEM DESCRIPTION SIZE REV

BILL OF MATERIALS

NOTES

COMMODITY

NOTES:TUBING RUNS LESS THAN 0.6m LONG AT INSTRUMENTS & CONTROL VALVES NEED NOT BE SUPPORTED.SUPPORT OF RACEWAY FROM PIPE SUPPORTS OR ANY PERMANENT STRUCTURE MEMBER IS PREFERRED.FLATBAR, ANGLE OR UNISTRUT MAY BE USED TO ATTACH RACEWAY TOSUPPORT MEMBER. COORDINATION WITH OTHER TRADES IS REQUIRED.MAXIMUM RACEWAY SPAN BETWEEN SUPPORTS IS 2m.MANUFACTURE ELBOWS AND TEES BY BENDING HEATED RACEWAY OR WELDING IN THE CASE OF TEES. THIS ALLOWS RACEWAY SIZE CHANGES.RACEWAY RUNS SHALL BE OF CONTINUOUS INSTALLATION.CONTINUOUS RUNS OF TUBING ARE PREFERRED BUT TUBING UNIONS MAY BE USED. IF UNIONS ARE INSTALLED OFFSET THE TUBING TO ALLOW WRENCH ACCESS.SECURE TUBING INTO RACEWAY USING 3/8" SS BANDING. MAXIMUM DISTANCE BETWEEN BANDING IS 1m.RACEWAY TO BE INSTALLED TO PREVENT MOISTURE COLLECTION.RACEWAY TO BE PRIMED AND PAINTED.

RACEWAYWIDTH

( INCHES )TUBING O.D.( INCHES )

1/4 3/8 1/2

1

1-1/2

2-1/2

3-3/8

3 2 2

6 3 2

9 6 4

12 8 6

MAX. No. TUBES IN RACEWAY

RACEWAY WIDTH( INCHES )

PREFORM & DRILL FROM 1-½” X ¼” FLATBAR. BRACKETS TO MOUNT ON CONCRETE COLUMNS.

PIPE CLAMP

ALT. MTGEITHER WELD RACEWAY TO

STEEL COLUMNS OR

USE LINDAPTERS

NOTE 2

ELBOWS or TEESNOTE 5

NOTE 1

SS BANDINGNOTE 8

1. REFER TO DRAWING (LEFT) FOR NOTES.

1.

2.

3.

4. 5.

6. 7.

8.

9. 10.

RACEWAY

FLATBAR

BANDING

CHANNEL RACEWAY, CS, A36, ROLLED

TOTAL REQUIRED CHANNEL RACEWAY (m)

= SUM OF QUANTITIES SHOWN ON INDIVIDUAL INSTALLATION DETAILS

1" x 3/8" x 1/8"

FLATBAR, CS, A36

TOTAL REQUIRED FLATBAR (m) = TOTAL REQUIRED CHANNEL RACEWAY x 0.075

1 1/2" x 1/4"

BANDING, 304SS

TOTAL REQUIRED BANDING (m) = TOTAL REQUIRED CHANNEL RACEWAY x 0.125

3/8" x 0.016"

REVISION DESCRIPTIONDATEREV

WINTERIZATION SPEC.

PIPE/TUBE SPEC.

MAX OP. TEMP.

MAX OP. PRES.

“This drawing is prepared solely for the use of the contractual customer of WorleyParsons Canada Services Ltd. and WorleyParsons Canada Services Ltd. assumes no liability to any other party for any representations contained in this drawing.”

DWG No. SHT. No. REV

1 of 1

INSTRUMENT INSTALLATION TYPICALTUBING SUPPORT

AGS.05.91-01

n/a

n/a

n/a

WORLEYPARSONS PROJECT No

CUSTOMER

n/a

Template Rev 0, August 2009