98576783_380-350_Korea Seite 9 Mittwoch, 20. Februar 2008 9:26 09

2

98576783_380-350_Korea Seite 2 Mittwoch, 20. Februar 2008 9:26 09

3

98576783_380-350_Korea Seite 3 Mittwoch, 20. Februar 2008 9:26 09

4

98576783_380-350_Korea Seite 4 Mittwoch, 20. Februar 2008 9:26 09

5

98576783_380-350_Korea Seite 5 Mittwoch, 20. Februar 2008 9:26 09

6

Our products are designed to meet the highest standards of quality, functionality and design. We hope you enjoy your new Braun Shaver.

Warning

• Your shaver is provided with a special cord set with an integrated Safety Extra Low Voltage power supply. Do not exchange or manipulate any part of it. Otherwise there is risk of electric shock.

• This appliance is not intended for use by children or persons with reduced physical or mental capabilities, unless they are given supervision by a person responsible for their safety. In general, we recommend that you keep the appliance out of reach of children.

Description

1 Shaver foil2 Cutter block3 Release button4 On/off switch («start/stop»)5 Long hair trimmer6 Charging light (green) 7 Low-charge light (red)

(380 model only)8 Replacement light for shaving parts9 Reset button

10 Special cord set

Charging

The best environmental temperature for charging is between 15 °C and 35 °C.• Using the special cord set, connect the

shaver to an electrical outlet with the motor switched off.

• When charging for the first time, leave the shaver to charge continuously for 4 hours.

• Once the shaver is completely charged, discharge the shaver through normal use. Then recharge to full capacity. Subsequent charges will take about 1 hour.

• A full charge provides up to 50 minutes of cordless shaving time depending on your beard growth.

• Maximum battery capacity will only be reached after several charging/discharging cycles.

• If the rechargeable batteries are discharged, you may also shave by connecting the shaver to an electrical outlet via the special cord set.

Charging light

The green charging light blinks when the shaver is being charged. When the battery is fully charged, the charging light lights permanently.

Low-charge light

(380 model only)The red low-charge light flashes when the battery capacity has dropped below 20%, provided the shaver is switched on. The re-maining capacity will then be sufficient for 2 to 3 shaves.

Shaving

Turn on the shaver («start»):The pivoting cutting system automatically adjusts to every contour of your face.

Trimmer:

When the long hair trimmer is activated, it allows the controlled trimming of moustache or sideburns.

Tips for the perfect shave

• We recommend that you shave before washing, as the skin tends to be slightly swollen after washing.

• Hold the shaver at right angles (90°) to the skin. Stretch the skin and shave against the direction of beard growth.

• To maintain 100% shaving performance, replace the shaver foil and cutter block, when the replacement light (8) comes on (after about 18 months), or when the shaving parts are worn.

English

98576783_380-350_Korea Seite 6 Mittwoch, 20. Februar 2008 9:26 09

7

Cleaning

This appliance is suitable for cleaning under an open water tap. Warning: Detach the hand-held part

from the power supply before cleaning it in water.

Regular cleaning ensures better shaving performance. Rinsing the shaving head after each shave under running water is an easy and fast way to keep it clean:• Switch the shaver on (cordless) and rinse

the shaving head under hot running water. A natural based soap may also be used provided it contains no particles or abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.

• Next, switch off the shaver, remove the shaver foil and the cutter block. Then leave the disassembled shaving parts to dry.

• If you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the long hair trimmer and shaver foil.

Alternatively, you may clean the shaver using the brush provided:• Switch off the shaver. Remove the shaver

foil.• Using the brush, clean the cutter block and

the inner area of the shaver head. However, do not clean the shaver foil with the brush as this may damage the foil.

Keeping your shaver in top shape

About every four weeks, clean the cutter block with Braun cleaning agents.

Replacement light for shaving parts / Reset

To maintain 100% shaving performance, replace your foil and cutter block, when the replacement light for shaving parts (8) comes on (after about 18 months) or when worn. Change both parts at the same time for a closer shave with less skin irritation.(Shaver foil and cutter block: 31B/S)

The replacement light will remind you during the next 7 shaves to replace the shaving parts. Then the shaver will automatically reset the display.After you have replaced the shaving parts (foil and cutter block), use a ball-pen to push the reset button (9) for at least 3 seconds to reset the counter.While doing so, the replacement light blinks and goes off when the reset is complete. The manual reset can be done at any time.

Preserving the batteries

In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every 6 months approximately. Then recharge the shaver to full capacity. Do not expose the shaver to temperatures higher than 50°C for extended periods of time.

Environmental notice

This product contains rechargeable batteries. In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection points provided in your country.

Subject to change without notice.This product conforms to the European Directives EMC 2004/108/EC and Low Voltage 2006/95/EC.

For electric specifications, see printing on the special cord set.

98576783_380-350_Korea Seite 7 Mittwoch, 20. Februar 2008 9:26 09

98576783/II-08Korea/GB

98576783_380-350_Korea Seite 8 Mittwoch, 20. Februar 2008 9:26 09