Upload
brice-adams
View
226
Download
2
Tags:
Embed Size (px)
Citation preview
Designed 2nd Generation uMouse Chassis and board by 12/02
All Major Hardware updates completed by 12/10
Original Promised goals:General movement algorithm
Result: Smart intersection and corner handling algorithms implemented
Wall tracking algorithmResult: Follows walls according to the right hand rule, can accurately map out distances, but the two programs have not been merged yet
Backtracking algorithmResult: Has not been implemented due to change in chassis design. But robot will return to last intersection and continue following the right hand rule.
Updated goals:Distance Tracking algorithm
Result: Pulse/Distance curve has been obtained for one particular program, a crude “best-fit” algorithm provides adequate and accurate distance measuring.
Wander throughout the maze following Right hand Rule
Result: As of 12/11 the bot will navigate relatively reliably and can count the number of turns it has made.
Solve the mazeResult: Distance tracking and Movement algorithms have not been combined due to space and time constraints.
To be honest, my uMouse had no mapping algorithm implemented at the time of filming
Followed 18 turns and then stoppedMaze had to be RHR solvableMaze had to have no dead ends when following the RHR (as of 12/11 that problem has been fixed)Bot was in “debug mode” therefore was stopping at every intersection to announce it’s next decision audibly
To be honest, my uMouse still had no mapping algorithm implemented at the time of filming
Stopped filming when the bot found the centerMaze had to be RHR solvableBot was in “Regular mode” and therefore moved faster and did not announce it’s decisions.
It can navigate a maze relatively reliably following the RHR. Occasionally it does slip up due to semi known bugs in implemented algorithm. It can measure any distance traveled in a straight line and report how many blocks it has moved audibly.It can also enter a debug mode based on the current algorithm
Boebot was too big to make 90 Degree turnsCode for turning was predicted to be too bigNavigating out of dead ends would be difficult
No good place to mount sensorsFor testing, sensors were friction fitted to the sidesSensor placement would require unwanted extensive permanent modification to the BOE-bot
Distance measuring was not linearSolution: Create a best fit algorithm to compensate under the conditions of the maze
Allocated battery space was too smallSolution: Cut off protrusions
“Canned” moves were not reliable during complicated sections of the mazeSolution: Designed and implemented a “smart turning” algorithm that it allowed it to correct it’s alignment when possible
Voltage regulator too hot, cutting power in the middle of a programSolution: Use a larger heat sink
ADC suddenly stopped reporting values from left hand sideAnalysis of problem:
Port on ADC died. Will only report a value of 255 when queriedSharp Distance sensor also died. Will only report a voltage value of 1.85v to 1.90v
Solution: Rewire spare ADC port to spare Sharp distance sensor.
Power appears to cut out randomly while in the middle of executionSolution: NOT SOLVED YETPartial solution: Smart Turning has been implemented so the robot does not crash if the robot experiences a power loss. Mapping data is still lostPossible causes:
Damaged Voltage regulatorInsufficient regulator coolingErrant subroutine “Return” command
Insufficient program space to combine mapping with navigationSolution: NOT SOLVED YETProposed Solution:
Optimize Navigation and Mapping programs to reduce space consumption“Return to start” program has not been implemented
Solution: NOT SOLVED YETProposed Solution:
Once mapping and navigation can be combined in one program, create a list of intersections in scratchpad ram to be passed onto a secondary “return to start” program
“Fastest route to center” program has not been implementedSolution: NOT SOLVED YETProposed Solution:
If all the above problems are cleared, Read back scratchpad ram (supposedly a correct maze) to get to the center“Even faster method of getting to the center” program has not been implemented
Solution: NOT SOLVED YETProposed solution:
If all the above problems are cleared, Implement creative, but smart methods of navigating particular turns with S-turns and similar motor controlling techniques