Upload
jase-pendley
View
224
Download
3
Tags:
Embed Size (px)
Citation preview
AN INTRODUCTION TO GLUED RIGS
A step by step guide to making professional looking rig bodies using the Rig Glue and Glue Tube system
Christchurch Angling Centrewww.seamatchfishing.co.uk
Equipment you will need
For this exercise you will need the following items:
Scissors Rig Glue Line Rest Glue Tubing (Here we use 0.5 Tube) Line (Here we use 0.5mm Line) Two Beads A Swivel
Step 1
Using Sharp scissors cut two small pieces of tubing to the desired length. For this demonstration we use 4mm length
pieces.
Step 2
Now thread your components onto the line, in the same order you would a crimp rig.
Tube, Bead, Swivel, Bead and Tube.
Step 3
Now place your rig onto the Line Rest so the components are in between the blue line
holders.
Step 4
Slide all the components to one side of the Line Rest. Carefully squeeze out a SMALL drop of glue and dab it onto the line. You may wish to use a cocktail stick to apply
the glue.
Step 5
Slide the first bit of tubing up to and over the drop of glue. Try and do this in a slow and positive motion. The glue will draw
into the tube and should fill the tube completely.
Step 6
Repeat the process for the other side.
Step 7
The finished product. Once mastered, it is easy to do three lots on one jig in very
little time!