PRODUCT INFORMATION FEBRUARY 25, 2005 582-Y 90 Degree Bolt Pattern Identification Torque converter covers that have no markings or have a 90 degree mark do not have the offset mounting lug that has been a typical Chrysler trademark. Chrysler began changing mounting lug configurations in 1996. Torque converter covers that have a circle in either of the two locations shown in figure number two at the right will have a two degree offset mounting lug. Figure # 1 With 90 Degree Mounting Pads Figure # 2 Depicts 2 Degree Offset Mounting Pads For additional information, contact the Customer Service Dept. at Dacco Converters by calling 800-443-2226.
Torque converter coversthat have no markings orhave a 90 degree
mark donot have the offset mountinglug that has been a
typicalChrysler trademark. Chryslerbegan changing mountinglug
configurations in 1996.
Torque converter coversthat have a circle in eitherof the two
locations shownin figure number two at theright will have a two
degreeoffset mounting lug.
Figure # 1 With 90 Degree Mounting Pads
Figure # 2 Depicts 2 Degree OffsetMounting Pads
For additional information, contact the Customer Service Dept.
at Dacco Converters by calling 800-443-2226.
![INDEX []...CHRYSLER 41TE (A604) NEW TRANSMISSION RANGE SENSOR CHANGE: Beginning at the start of production 1996, some models equipped with the 41TE (A604) transaxle replaced the PRNODL](https://img.pdfslide.net/doc/110x75/606d56ab1430b51d6c06918d/index-chrysler-41te-a604-new-transmission-range-sensor-change-beginning.jpg)
