Upload
others
View
4
Download
0
Embed Size (px)
Citation preview
EST-ITW Copyright © 2012 Form 800-7 Patented Technology
High amplitude EDMdischarge pattern
High Peak to Peak common mode voltage
Low amplitude voltagedischarge pattern
The following types of readings indicate potential bearing currents in your motor:
Measuring VFD Induced Shaft VoltagesIs your motor safe from destructive shaft voltages? For the first time you can easily and more accurately measure the voltage on a rotating shaft. The AEGIS® SVP Shaft Voltage Probe’s unique design of high density conductive microfibers ensures continuous contact with the rotating shaft. Used with the Fluke 190 Series II ScopeMeter®, you can determine if your motor is subject to potentially damaging bearing currents. The AEGIS® SVP may be hand held or used with a magnetic base. Simply contact the rotating shaft with the microfibers and evaluate the voltage waveform on the oscilloscope.
AEGIS® SVP Shaft Voltage Test KitConductive Microfiber Probe for usewith Fluke 190 Series II ScopeMeter®
AEGIS® SGR Bearing Protection RingUse the AEGIS SGR® Bearing Protection Ring to prevent electrical bearing damage by safely channeling harmful shaft voltages away from the bearings to ground. The conductive microfibers provide the path of least resistance and dramatically extend motor life.
For more inquiries:
Ph 1-866-738-1857Fax [email protected]
www.est-aegis.com
Installation with Fluke VPS410 10:1 probe
1. Remove the protective cap 2. Remove the plastic sleeve 3. Probe with sleeve removed
4. Attach ground lead 5. Install the AEGIS® SVP tip over the probe tip
6. Secure the tip to the probe using the thumb screw. Be careful not to over tighten.
BENEFITS• Measure Shaft Voltage
• Predictive Maintenance
• Diagnose the Cause of EDM Bearing Failure
SVP-KIT-3000MB
SVP-KIT-3000
SVP-TIP-3000
AGS-KIT-1
For additional information download the SVP Shaft Voltage Training Module from our website.www.est-aegis.com
The AEGIS® Grounding Simulator (AGS-KIT-1) is used with the AEGIS® SVP to apply AEGIS® shaft grounding in a test-mode. The AGS-KIT-1 simulates the reduction of shaft voltage achieved with AEGIS® SGR installed.
EST-ITW Copyright © 2012 Form 800-7 Patented Technology
Catalog Number Includes:
SVP-KIT-3000MB3 SVP tips, probe holder with two piece extension rod (total length of probe holder with extension rod is 18 inches) and magnetic base. AEGIS® Grounding Simulator (AGS-KIT-1) included.
SVP-KIT-3000 3 SVP tips, probe holder with two piece extension rod. AEGIS® Grounding Simulator (AGS-KIT-1) included.
SVP-TIP-3000 3 SVP tips
AGS-KIT-1 Grounding brush, two piece extension rod, ground cable
Fits Fluke Voltage Probe VPS410 and VPS200
SVPS H A F T V O LT A G E P R O B E
®