After 2.2 Revised Which cable(s) are crossover cables in this diagram? A.A B.B C.C D.D E.None of the above Q 1 of 5 How many subnets are there in this network? A.1 B.2 C.3 D.4 E.Some other number Q 2 of 5 Which command gives output like this? A.show run B.show ip int brief C.show interfaces D.show ip route E.show start Q 3 of 5 Which command gives output like this? A.show run B.show ip int brief C.show interfaces D.show ip route E.None of the above Q 4 of 5 Which interface requires the clock rate command? A.A B.B C.C D.D E.E Q 5 of 5 A BC D E After 2.3 When is the route added to the routing table on R1? A.As soon as the router powers up B.As soon as the interface is enabled, even if no cable is connected C.As soon as the interface is enabled, with correct IP configuration, and a cable is connected D.When packets begin to flow through the interface E.Not until the administrator adds the route manually Q 1 of 4 When is the route added to the routing table on R1? A.As soon as the router powers up B.As soon as the interface is enabled, even if no cable is connected C.As soon as the interface is enabled and a cable is connected D.When packets begin to flow through the interface E.Not until the administrator adds the route manually Q 2 of 4 All interfaces are configured and cables are connected, but only directly connected routes are present in the routing tables. Which devices can PC1 ping successfully? A.PC1 can ping R1, R2, and PC2 B.PC1 can ping R1 and R2 but not PC2 C.PC1 can ping R1, but not R2 or PC2 D.PC1 cannot ping R1, R2, or PC2 E.None of the above Q 3 of 4 All the routers and switches are Cisco products with CDP enabled. The show cdp neighbors command is executed on R1. Which devices appear in the output? A.No devices B.Switch0 only C.Switch0 and R2 D.Switch0, Switch1, and R2 E.None of the above Q 4 of 4 After 2.6 Which command is best to add an appropriate static route to R1? A.ip route fa0/0 B.ip route s0/0 C.ip route fa0/0 D.ip route s0/0 E.None of the above Q 1 of 5 Which command is best to add an appropriate static route to R1? A.R1>ip route s0/0 B.R1#ip route s0/0 C.R1(config)#ip route s0/0 D.R1(config-if)#ip route s0/0 E.None of the above Q 2 of 5 Which command is best to add an appropriate static route to R1? A.ip route B.ip route C.ip route D.ip route E.ip route s0/0 Q 3 of 5 Answer Note that specifying the exit interface is better than specifying the next hop because it prevents a recursive lookup What summary route best combines these static routes? A B C D E Q 4 of 5 What summary route best combines these static routes? A B C D E Q 5 of 5