Section 10.1 Air Compressor FlangeThe air compressor flange is attached to the air compressor housing. Perform the following procedures for removal and installation of the air compressor flange and O-ring.Section 10.1.1 Removal of Air Compressor FlangeRemove as follows:

1. Shut off engine and apply the parking brake, chock the wheels, disconnect vehicle battery power, and perform any other applicable safety steps.

2. Remove the two bolts attaching the power steering pump to the air compressor. Note: Do not remove the power steering lines. Tie up the lines and move the pump out of the way.

1. Power Steering Pump Mounting Bolt

5. Air Compressor Housing 2. Power Steering Pump 6. Air Compressor

Mounting Bolt 3. O-ring 7. Air Compressor Flange

Página 1 de 3Power Service Literature

04/10/2015https://extranet-ddc.freightliner.com/power_service/literatu...

4. Cross PlateFigure 1. Air Compressor

3. Remove the cross plate between the compressor and the power steering pump.

4. Discard the O-ring between the power steering pump and the air compressor. NOTICE:When removing the flange, make sure not to damage the crankshaft journal or crankshaft bearing.

5. Remove the four bolts attaching the air compressor flange to the air compressor housing.

6. Discard O-ring between the air compressor flange and air compressor housing.

7. Inspect air compressor flange, bearing, and O-ring surfaces for damage. Replace if necessary.

Section 10.1.2 Installation of Air Compressor FlangeInstallation steps are as follows:

1. Install the new O-ring between the air compressor flange and air compressor housing. NOTICE:Make sure to not damage the crankshaft journal or crankshaft bearing while installing.

2. Install the air compressor flange using the four bolts. Torque to 30 N·m (22 lb·ft). Note: Use grease to hold the cross plate in place while installing the power steering pump.

3. Install the cross plate. NOTICE:Make sure not to damage the bolt threads when installing the power steering pump to the air compressor.

4. Install the two bolts attaching the power steering pump to the air compressor. Torque to 40 N·m (30 lb·ft).

EPA04 MBE 4000 Workshop Manual (DDC-SVC-MAN-0023)

Printed Sun Oct 04 2015 21:29:11 GMT-0600 (Hora estándar, América Central)

Copyright © 2015 by Detroit Diesel Corporation. All rights reserved.Generated on 09-30-2015

Página 2 de 3Power Service Literature

04/10/2015https://extranet-ddc.freightliner.com/power_service/literatu...

Página 3 de 3Power Service Literature

04/10/2015https://extranet-ddc.freightliner.com/power_service/literatu...