LS 195

Aktives Super Slim 2.1 System mit Subwoofer

LS 195

2

LS 195

3

LS 195

4

LS 195

5

LS 195

6

LS 195

7

LS 195

8

LS 195

9

LS 195

10

LS 195

11

LS 195

12

LS 195

13

LS 195

14

LS 195

15

LS 195

16

LS 195

Woofer Rear-L Front-L

Center Rear-R Front-R Video

DVD Player

TV

17

LS 195

18

LS 195

CD TV C1 C2 OP

19

LS 195

20

LS 195

21

LS 195

22

LS 195

23

LS 195

24

LS 195

25

LS 195

26

LS 195

The normal function of the product may be disturbed by strong Electro-Magnetic Interference. If so, simply replug and power on reset the product to resume the unit operation by following the instruction manual. In case the function could not resume, please use the product in other location, or ask a service.

27

ConformityModel number: LS 195Description: Brand name: Blaupunkt Responsible party: M3 Electronic GmbH Gutenbergstrasse 5, D-65830 Kriftel. Germany Hereby, Blaupunkt Competence Center Audio M3 Electronic GmbH, declares that this Class 1 equipment is in compliance with the essential requirement and other relevant provisions of Directive 1999/5/EC. Letter of conformity can be obtained from info@m3-electronic.de.

Active Super Slim 2.1 System with Subwoofer

Safety Instructions

1. READ INSTRUCTIONS – All the safety and operating instructions should be read before appliance's operated.

2. RETAIN INSTRUCTIONS - The safety and operating instructions should be retained for future reference.

3. HEED WARNINGS – All warnings on the appliance and in the operating instructions should be adhered to.

4. FOLLOW INSTRUCTIONS – All operating instructions should be followed.

5. WATER AND MOISTURE – The appliance should not be used near water, for example, near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in web basement.

6. VENTILATION – The appliance should be situated so that its location or position does not interfere with its proper ventilation. Do not place on bed, sofa, rug or similar surface that may block the ventilation openings, in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings.

7. HEAT – The appliance should be situated away from heat sources such as radiators, stoves, or other appliances (including amplifiers) that produce heat.

8. POWER SOURCE – the appliance should be connected to power supply only of the type described in the operating instructions or as marked on the appliance.

9. POWER CORD PROTECTION – power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them.

10. POWER LINES – an outdoor antenna should be located away from power lines.

11. OBJECT AND LIQUID ENTRY – care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings.

LS 195

28

12. ESD WARNING – the display does not function properly or not reaction to operation of any the control may due to the electrostatic discharge. Switch off and unplug the set. Reconnect after a few seconds.

13. DAMAGE REQUIRING SERVICE – the appliance should be serviced by qualified service personal when: a. the power-supply cord or plug has been damaged. b. Objects have fallen into, or liquid has been spilled into the appliance enclosure. c. The appliance has been exposed to rain. d. The appliance has been dropped, or the enclosure damaged. e. The appliance does not appear to operate normally.

14. SERVICING – the user should not attempt to service the appliance beyond that described in the user operation instructions. All other servicing should be referred to qualified service personnel.

15. DO ensure that all electrical connections (including the mains plug, extension leads and inter-connections between the pieces of equipment) are properly made and in accordance with the manufacturer's instructions. Switch off and unplug the power before making or changing connections.

16. Unplug this apparatus during lightning storms or when unused for long periods of time.

17. Never unplug your radio by pulling on the power cord. Always grasp the plug firmly and pull straight out from the outlet.

18. DON'T remove any fixed cover as this may expose dangerous voltages.

19. DON'T place hot objects or naked flame sources such as lighted candles or nightlight on, or close to equipment. High temperatures can melt plastic and lead to fires.

20. DON'T leave equipment switched on when it is unattended unless it is specifically stated that it is designed for unattended operation. Switch off using the switch on the equipment and make sure that your family knows how to do this. Special arrangements may need to be made for infirm or handicapped people.

21. DON'T continue to operate the equipment if you are in any doubt about if it's working normally or if it's damaged in any way. Switch it off, unplug the mains power and consult your dealer.

22. REPAIR OR REPLACE all electric service cords that have become frayed or otherwise damaged immediately. Do not use a cord that shows cracks or abrasion damage along its length, the plug, or the connector end.

23. DON'T place objects filled with liquids, such as vases on the apparatus.

24. Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.

25. The mains plug shall remain readily operable.

LS 195

29

26. Ensure a minimum distance of 5cm around the apparatus for sufficient ventilation.

27. The ventilation should not be impeded by covering the ventilation opening with items such as newspapers, table-cloths, curtains, etc.

28. The batteries should be drawn to the environmental aspects of batter y disposal.

Front panel - controls and functions

1. STANDBY: Power Standby Button.2. INPUT:Input Selection Button.3. STANDBY: Power Standby Indicator.4. LED Display.5. Remote Sensor.6. VOL-: Volume Down Button.7. VOL+: Volume Up Button.

LS 195

30

Rear panel - controls and functions

1. Optical Input.2. Coaxial 1 Input.3. TV Stereo Left Audio Input.4. CD Stereo Left Audio Input.5. Power On/Off Switch.6. AC Power Cord.7. Speaker Output.8. Coaxial 2 Input.9. TV Stereo Right Audio Input. Notice: When DVD player is working and PCM mode is chosen, the device works; otherwise, the devise cannot recognize the source.10. CD Stereo Right Audio Input.11. Speaker Input.

LS 195

31

System connection instructions

Video InTo Stereo Output

RCA Cable

Woofer Rear-L Front-L

Center Rear-R Front-R Video

Video Out

Audio Out

DVD Player

TV

LS 195

32

Remote control

LS 195

1. STANDBY: Power Standby.2. MUSIC: Music Mode Selection.3. NORMAL: Normal Mode Selection.4. VOL-: Volume Down Button.5. BASS-: Bass Down Button.6. TREBLE-: Treble Down Button.7. INPUT: Input Selection Button .

8. MUTE: Mute Function Button.9. RESET: Location Retrieval Button.10. MOVIE: Movie Mode Selection.11. VOL+: Volume Up Button.12. BASS+: Bass Up Button.13. TREBLE+: Treble Up Button.

CD TV C1 C2 OP

33

Remote control battery replacement

1. Please remember to replace the battery when can not workable or weakness function.2. Use only CR2025 3V lithium batteries3.Bear in mind that lighting & other room conditions, in addition to battery age, can affect the operating range of an infrared remote control.4. Battery disposal: Batteries and rechargeable batteries are prohibited to dispose intohousehold waste.

LS 195

34

LS 195

Operation

A.Switch On/Off the Product1.Before turn on the system, please connect it according to the System Connection Instruction.2.Plug on and connect AC power supply with this product.(Caution: Power source must be consistent with specification.)3.Press on the POWER switch button on the Rear Panel of the main unit to switch on the system, the standby indicator will light up. Then press the STANDBY button on the remote controller to enter the normal status. Press the button on the remote controller once again to keep power in standby status.

B. VOLUME Selection1.Press the VOL + button on the front of the main unit, or the VOL + button on the remote control to increase the volume.2.Press the VOL - button on the front of the main unit, or the VOL - button on the remote control to decrease the volume.

C. TREBLE Selection1.Press the TREBLE + button on the remote control to increase the treble level.2.Press the TREBLE - button on the remote control to decrease the treble level.

D. BASS Selection1.Press the BASS + button on the remote control to increase the bass level.2.Press the BASS - button on the remote control to decrease the bass level.

E. MUTE Selection1.Press the MUTE button on the remote controller once to keep the performance silent. Press "Mute" again to cancel mute function and the main volume instruction light will be flashing.

F. Analog/digital input and PCM decoder.1. Our soundbar system provide two analog inputs and one optical & two coaxial inputs. You can play and entertain your home music depend on your music device input. Please use properly cable for connecting first, then switch to mode accordingly.2. Our soundbar also built-in PCM decoder, but please kindly note that only can work when you set up the input music device in PCM mode, like DVD or TV ect.

35

This symbol on the product or in the instructions means that your electrical and electronic equipment should be disposed at the end of its life separately from your household waste. There are separate collection systems for recycling in the EU.For more information, please contact the local authority or your retailer where you purchased the product.

All rights reserved by Blaupunkt Competence Center Audio M3 Electronic GmbH. This material may be reproduced, copied or distributed for personal use only.

1.Power Supply..........................................................................................................AC 230V/50Hz2.Total THD 10% Pass Power Output.... ..................................................................................80W 3.Subwoofer Power Output ......................................................................................................40W 4.Soundbar Power Output ..................................................................................................2 x 20W 5.Input Sensitivity (Subwoofer)............................................................................. 200mV 20mV 6.Input Sensitivity (Soundbar)................................................................................750mV 50mV 7.Speaker Impedance (Subwoofer)......................................................................................8 Ohm8.Speaker Impedance (Soundbar)........................................................................................8 Ohm 9.S/N (A Weight).........................................................................................................................80dB 10.THD (1kHz, 1W)......................................................................................................................0.5% 11.Frequency Response (Subwoofer).......................................................... .20Hz~150Hz 3dB 12.Frequency Response (Soundbar).............................................................200Hz~20KHz 3dB13.L/R Separation (1kHz)..........................................................................................................30dB 14.L/R Balance (Stereo)............................................................................................................. 2dB

..

..

LS 195

36

Specifications